User's Manual
Table Of Contents
- Copyright Notice
- Serviceability of this Manual
- Operational Safety Notices
- FM/UL/CSA Notice MDS iNet 900 When Approved
- FM/UL/CSA Conditions of Approval MDS iNet 900 When Approved
- FCC Notice, U.S.A. MDS iNet 900 When Approved
- FCC Information
- 1.0 ABOUT THIS MANUAL
- 2.0 PRODUCT DESCRIPTION
- 3.0 INSTALLATION PLANNING
- 4.0 INSTALLATION
- 4.1 Step 1— Mounting the Transceiver
- 4.2 Step 2—Install the Antenna and Feedline
- 4.3 Step 3—Connect the Data Equipment
- 4.4 Step 4—Measure & Install Primary Power
- 4.5 Step 5—Review the Radio’s Configuration
- 4.6 Step 6—Connect the User Data Equipment
- 4.7 Step 7—Check for Normal Operation
- 4.8 Performance Optimization
- 5.0 TRADITIONAL REPEATER CONFIGURATION WITH TWO RADIOS
- 6.0 PROGRAMMING
- 7.0 TROUBLESHOOTING
- 8.0 REPEATER ASSITED LANS
- 9.0 TECHNICAL REFERENCE
- 10.0 GLOSSARY OF TERMS
- IN CASE OF DIFFICULTY...
MDS 05-2873A01, Rev. A MDS iNet 900 Installation and Operation Guide 25
DRAFT 6—8/29/01
Invisible place holder
Figure 15. Management Toolbox Start-up Screen
Navigation
From the Main Menu you navigate by pressing the key to the left of the
offering. You will then be taken to a screen associated with that func-
tion. If you select a menu item that is not user-configurable, the message
“
Note: This is not a configurable item.” Pressing the ESCAPE
key will navigate you to the previous menu or level.
Help Pressing F1 from any menu will place the Management Toolbox in the
Help mode; pressing the key corresponding to the menu item will pro-
vide you with useful information or instructions. Pressing the
ESCAPE
key will exit the Help Mode and return you to the previous screen.
Logging In and
Password
All screens are accessible to any user. To change a user-controllable
parameter, you must log into the system and enter a password. The
default user password is “
admin” in lowercase letters. The main menu
item will change from
Login to Logout. The user will automatically be
logged out after 10 minutes of inactivity.
1
Z?
If you know that you want in advance to change one or more parameter,
you should log in from the Main Menu.
Logging Out Once you are logged in, you can go to the System Configuration Menu and
change the password (case-sensitive). Follow any changes to the pass-
word or other parameters with an
ENTER key to save the change.
1. This is a guess. Please verify value and function