User's Manual
Table Of Contents
- Copyright Notice
- Serviceability of this Manual
- Operational Safety Notices
- FM/UL/CSA Notice MDS iNet 900 When Approved
- FM/UL/CSA Conditions of Approval MDS iNet 900 When Approved
- FCC Notice, U.S.A. MDS iNet 900 When Approved
- FCC Information
- 1.0 ABOUT THIS MANUAL
- 2.0 PRODUCT DESCRIPTION
- 3.0 INSTALLATION PLANNING
- 4.0 INSTALLATION
- 4.1 Step 1— Mounting the Transceiver
- 4.2 Step 2—Install the Antenna and Feedline
- 4.3 Step 3—Connect the Data Equipment
- 4.4 Step 4—Measure & Install Primary Power
- 4.5 Step 5—Review the Radio’s Configuration
- 4.6 Step 6—Connect the User Data Equipment
- 4.7 Step 7—Check for Normal Operation
- 4.8 Performance Optimization
- 5.0 TRADITIONAL REPEATER CONFIGURATION WITH TWO RADIOS
- 6.0 PROGRAMMING
- 7.0 TROUBLESHOOTING
- 8.0 REPEATER ASSITED LANS
- 9.0 TECHNICAL REFERENCE
- 10.0 GLOSSARY OF TERMS
- IN CASE OF DIFFICULTY...
MDS 05-2873A01, Rev. A MDS iNet 900 Installation and Operation Guide 33
DRAFT 6—8/29/01
The connector uses the standard Ethernet RJ-45 cables and wiring.
Figure 18. LAN Port (RJ-11) Pinout
(Viewed from the outside of the radio.)
COM1 Port
Figure 19. COM1 Port
(Viewed from the outside of the radio.
Table 9-7. LAN Port (IP/Ethernet)
Pin Functions Ref.
1 Transmit Data (TX) High
2 Transmit Data (TX) Low
3 Receive Data (RX) High
4 Unused
5 Unused
6 Receive Data (RX) Low
7 Unused
8 Unused
Table 8. COM1 Port Pinout
Pin Functions DCE
1 Unused
2 Receive Data (RXD) <—[ Out
3 Transmit Data (TXD) —>[ In
4 Unused
5 Signal Ground (GND)
6 Unused
7 Unused
8 Unused
9 Unused
1 2 3 4 5 6 7 8
1
5
9
6