User's Manual
Table Of Contents
- Copyright Notice
- Serviceability of this Manual
- Operational Safety Notices
- FM/UL/CSA Notice MDS iNet 900 When Approved
- FM/UL/CSA Conditions of Approval MDS iNet 900 When Approved
- FCC Notice, U.S.A. MDS iNet 900 When Approved
- FCC Information
- 1.0 ABOUT THIS MANUAL
- 2.0 PRODUCT DESCRIPTION
- 3.0 INSTALLATION PLANNING
- 4.0 INSTALLATION
- 4.1 Step 1— Mounting the Transceiver
- 4.2 Step 2—Install the Antenna and Feedline
- 4.3 Step 3—Connect the Data Equipment
- 4.4 Step 4—Measure & Install Primary Power
- 4.5 Step 5—Review the Radio’s Configuration
- 4.6 Step 6—Connect the User Data Equipment
- 4.7 Step 7—Check for Normal Operation
- 4.8 Performance Optimization
- 5.0 TRADITIONAL REPEATER CONFIGURATION WITH TWO RADIOS
- 6.0 PROGRAMMING
- 7.0 TROUBLESHOOTING
- 8.0 REPEATER ASSITED LANS
- 9.0 TECHNICAL REFERENCE
- 10.0 GLOSSARY OF TERMS
- IN CASE OF DIFFICULTY...
MDS 05-2873A01, Rev. A MDS
i
Net 900 Installation and Operation Guide v
DRAFT 6—8/29/01
ment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct
the interference at his own expense.