User's Manual

24 MDS TransNET I/O Guide MDS 05-2708A01, Rev. A
SET/PROGRAM COMMANDS
ADDR [1...65000]
Details Page 26
Program network address
AMASK [0000
0000–FFFF FFFF]
Details Page 27
Sets alarm response. Default is FFFF FFFF.
ASENSE [HI/LO]
Details Page 27
Changes the sense of the alarm output. Default
sense is HI.
BAUD [xxxxx abc]
Details Page 27
Set data communication parameters
CTS [0–255]
Details Page 28
Program CTS delay in milliseconds.
(A value of 0 returns CTS immediately)
CTSHOLD [0-6000]
Details Page 28
Set/display “hold time” that CTS remains
present following last character transmission
from DD-25 port.
DEVICE [DCE, CTS
KEY]
Details Page 28
Set device behavior; DCE (normal) or CTS Key
(Repeater)
MODE [M, R, R-M]
Details Page 30
Program operating mode, where M = Master,
R = Remote, R-M = Remote-Master (Remote
radio programmed to operate on Master fre-
quencies)
OWM [xxxxx]
Details Page 30
Program owner’s message
(30 characters maximum)
OWN [xxxxx]
Details Page 30
Program owner’s name
(30 characters maximum)
PWR [xx–30]
Details Page 30
Program forward power output in dBm.
RTU [ON/OFF/0-80]
Details Page 31
Re-enables or disables the radio’s internal RTU
simulator and sets the RTU address.
RXTOT [NONE,
0–1440]
Details Page 31
Specifies max. duration (in minutes) to wait
before issuing a time-out alarm. Default is OFF.
SEND [n, -n, +n]
Details Page 31
Sets/displays re-send count for data packets.
Useful in areas with heavy radio interference.
UNIT [10000–65000]
Details Page 34
Program unit address. Used to set a unique
address for network-wide diagnostics.
Table 5. Command summary (Continued)
COMMAND DESCRIPTION