User's Manual

A
Accessories (table) 14
ADDR command (set/display radio network address) 38
Alarm
checking for 50
code definitions 50
codes 50
codes, table 50
major vs. minor 50
receiver timeout (RXTOT command) 45
reset output signal 39
set/display output sense (ASENSE command) 39
status (STAT command) 48
ALARM command (obsolete; see STAT command) 48
AMASK command (configure alarm output signal) 39
Antenna
installation 26
performance optimization 32
selection 21
SWR check 32
system gain vs. power output setting, table 23
system gain, defined 14
Yagi, illustrated 22
ASENSE command (set/display alarm output sense) 39
B
BAUD command (set/display data interface port attributes) 39
Baud rate
setting 33
Bit, defined 14
BPS (bits-per-seond), defined 14
BUFF command (set/display received data handling mode) 40
Byte, defined 14
C
Cable
data equipment to DATA INTERFACE connector 26, 34
data interface wiring for null-modem 29
data interface wiring for tail-end links 28
feedlines 22
maximum length, recommended 26
null-modem, for repeater system 28, 29
power (positive/negative leads) 27
Commands
ADDR (set/display radio network address) 38
AMASK (configure alarm output signal) 39
ASENSE (set/display alarm output sense) 39
BAUD (set/display data interface port attributes) 39
BUFF (set/display received data handling mode) 40
CTS (set/display CTS line response timer) 40
CTSHOLD (set/display CTS hold timer) 41
detailed descriptions 35—??
DEVICE (set/display DCE or CTS Key behavior) 41
display operating status 37
DMGAP (set time to wait between characters) 42
DTYPE (set radio s diagnopstics type) 42
entering on Hand-Held Terminal (HHT) 35
Hand-Held Terminal (HHT) 34
HOPTIME (set/display hoptime setting) 42
how used 38
MODE (set/display master/remote operation) 43
most used 35, 38
network configuration 35
OWM (set/display optional owner s message) 43