User's Manual

OWN (set/display optional owner s name) 43
PWR (set/display RF forward output power) 43
RSSI (display received signal strength) 43
RTU (enable/disable internal RTU) 44
RX (set/display test receive frequency) 44
RXTOT (set/display received data timeout value) 45
SEND (set/display number of re-sends) 45
set/program 36
SETUP (enter testing and setup mode) 46
SHOW (display active port, dc volts, measured power output) 47
SIMPLEX (set/display simplex/half-duplex operation) 47
SKIP (set/display frequency zone to skip) 47
SKIPSYNC (set/display status of SYNC messages in skipped zones) 47
SNR (display signal-to-noise ratio) 47
SREV (display transceiver software version) 48
STAT (list alarms) 48
summary, table 35
TDD (set/display time division multiplex status) 48
TEMP (display internal temperature) 48
CTS command (set/display CTS line response timer) 40
CTSHOLD command (set/display CTS hold timer) 41
D
Data buffer setting 33, 40
DATA INTERFACE
connections 54
connector pin descriptions, table 55
connector pins, illustrated 55
Data interface
cable wiring for repeater, illustrated 29
cable wiring for tail-end links, illustrated 28
dBi, defined 14
dBm, defined 15
DCE, defined 15
Decibel (dB), defined 14
Default settings
data interface baud rate 33
DEVICE command (set/display DCE or CTS Key behavior) 41
Diagnostics
setup mode (SETUP command) 46
Display
alarm output sense (ASENSE command) 39
alarms (STAT command) 48
connector port, diagnostics (SHOW command) 47
CTS hold timer value (CTSHOLD command) 41
CTS line response timer value (CTS command) 40
data interface baud rate (BAUD command) 39
dc input/output voltages (SHOW command) 47
device behavior (DEVICE command) 41
hoptime setting (HOPTIME command) 42
master or remote operation (MODE command) 43
network address (ADDR command) 38
operating status commands 37
owner s message (OWM command) 43
owner s name (OWN command) 43
received data handling mode (BUFF command) 40
received data timeout value (RXTOT command) 45
received signal strength (RSSI command) 43
RF forward output power (PWR command) 43
RF power output, actual measured (SHOW command) 47
signal-to-noise ratio (SNR command) 47
simplex or half-duplex operation (SIMPLEX command) 47
skipped frequency zones (SKIP command) 47
software version, transceiver (SREV command) 48