User's Manual

temperature, internal (TEMP command) 48
test receive frequency (RX command) 44
DKEY command (dekey transmitter) 32, 38, 46
DMGAP command (set/display time to wait between characters) 42
DSP (Digital Signal Processing), defined 15
DTE, defined 15
DTYPE command (set radio s diagnostics type) 42
E
EEPROM FAILURE error message 35
Enable
internal RTU (RTU command) 44
master/remote operation (MODE command) 43
Setup mode (SETUP command) 46
simplex/half-duplex operation (SIMPLEX command) 47
skipped zone (SKIP command) 47
Sleep Mode 30
Equalization, defined 15
Error messages
on Hand-Held Terminal (HHT) 35
F
Fade margin, defined 15
Feedline
selection 21, 22
Frame, defined 15
Frequency hopping, defined 15
Frequency zone
defined 15
table 47
G
Gate (radio diagnostics type) 42
Glossary 14—17
H
Hand-Held Terminal (HHT)
command summary, table 35
entering commands 35
error messages 35
keyboard commands 34
Hardware flow control, defined 15
Hopping, defined 15
Hoptime
parameters, table 42
setting 33
HOPTIME command (set/display hoptime setting) 42
Host computer, defined 15
I
Illustrations
antenna, Yagi 22
data interface cable wiring for repeater 29
data interface cable wiring for tail-end links 28
DATA INTERFACE connector pins 55
LED status indicators 32
model configuration code 10
point-to-point link 12
remote station arrangement 18
repeater system configuration 13
simplex peer-to-peer network 12
tail-end link 13
transceiver 9
typical MAS network 11