User's Manual

power usage 23
Point-to-point system
link, illustrated 12
Poll, defined 16
Power
how much can be run 23
measuring and installing primary 27
set/display RF forward output (PWR command)Set
RF forward output power (PWR command) 43
sleep mode 30
Procedures
antenna aiming 32
antenna and feedline selection 21
antenna SWR check 32
connecting data equipment to DATA INTERFACE connector 26, 34
enabling sleep mode 30
entering commands using Hand-Held Terminal (HHT) 35
installation 24—31
installation planning 17
installing the antenna and feedline 26
interference check 33
measuring and installing primary power 27
mounting the transceiver 25
performance optimization 32
programming the radio 33—35, ??—35
reading LED status indicators 31
site selection 18
troubleshooting 49—52
Programming radio 33—??
PWR command (set/display RF forward output power) 43
R
Radio
inoperative (troubleshooting chart) 52
no synchronization with master (troubleshooting chart) 52
poor performance (troubleshooting chart) 52
Remote radio
defined 16
Remote station
typical arrangement, illustrated 18
Repeater
data interface cable wiring for, illustrated 29
installation 28
system, illustrated 13
Root (radio diagnostics type) 42
RSSI command (display received signal strength) 43
RTU (Remote Terminal Unit)
defined 17
RTU command (enable/disable internal RTU) 44
RX command (set/display test receive frequency) 44
RXTOT command (set/display received data timeout value) 45
S
SCADA (Supervisory Control and Data Acquisition), defined 17
SEND command (set/display number of re-sends) 45
Set
alarm output sense (ASENSE command) 39
alarm output signal (AMASK command) 39
CTS hold timer (CTSHOLD command) 41
CTS line response timer (CTS command) 40
data interface baud rate (BAUD command) 39
DCE or CTS Key device behavior (DEVICE command) 41
frequency zone to skip (SKIP command) 47
hoptime (HOPTIME command) 42