User's Manual

master/remote operation (MODE command) 43
network address (ADDR command) 38
owner s message (OWM command) 43
owner s name (OWN command) 43
received data handling mode (BUFF command) 40
received data timeout value (RXTOT command) 45
simplex or half-duplex operation (SIMPLEX command) 47
test receive frequency (RX command) 44
testing mode (SETUP command) 46
Set/program commands 36
SETUP command (enter testing and setup mode) 46
SHOW command (display active port, dc volts, measured power output) 47
Simplex
installing peer-to-peer system 27
peer-to-peer network, illustrated 12
SIMPLEX command (set/display simplex/half-duplex operation) 47
Site selection 18
SKIP command (set/display frequency zone to skip) 47
SKIPSYNC (set/display status of SYNC messages in skipped zones) 47
Sleep mode 30
SNR command (display signal-to-noise ratio) 47
SREV command (display transceiver software version) 48
STAT command (list alarms) 48
SWR (Standing Wave Ratio)
defined 17
performance optimization 32
T
Tables
accessories 14
alarm codes 50
antenna system gain vs. power output setting 23
DATA INTERFACE connector pin descriptions 55
frequency zones 47
Hand-Held Terminal (HHT) command summary 35
hop time parameters 42
LED status indicators 32
troubleshooting 52
Tail-end link
cable wiring for, illustrated 28
illustrated 13
installation 27
TDD (set/display time division multiplex status) 48
Technical reference 52—57
Technical specifications 52—54
TEMP command (display internal temperature) 48
Temperature, display internal (TEMP command) 48
Transceiver
connecting to data equipment 26, 34
illustrated 9
mounting instructions 25
performance optimization 32
sleep mode 30
Troubleshooting 49—52
table 52