User's Manual

MDS 05-2708A01 Rev. A MDS TransNET 900 I/O Guide v
Refer to Articles 500 through 502 of the National Electrical Code
(NFPA 70) for further information on hazardous locations and approved
Division 2 wiring methods.
FCC Part 15 Notice
The MDS TransNET 900“ transceivers comply with Part 15 of the
FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
This device is specifically designed to be used under Section 15.247 of
the FCC Rules and Regulations. Any unauthorized modification or
changes to this device without the express approval of Microwave Data
Systems may void the user s authority to operate this device.
Furthermore, this device is indented to be used only when installed in
accordance with the instructions outlined in this manual. Failure to
comply with these instructions may also void the user s authority to
operate this device.
Revision Notice
While every reasonable effort has been made to ensure the accuracy of
this manual, product improvements may result in minor differences
between the manual and the product shipped to you. If you have addi-
tional questions or need an exacts specification for a product, please
contact our Customer Service Team using the information at the back of
this guide. In addition, manual updates can often be found on the MDS
Web site at www.microwavedata.com.
Limited Modular Approval Notice
MDS TransNET radios are intended for use only inside an enclosure that
is fully compliant to FCC Part 15 requirements. These enclosures have
been tested with MDS radio products and meet the unintentional radi-
ator requirements as set forth by the FCC. MDS certifies that any future
enclosures offered with these products will meet the appropriate
requirements and will not offer the products to end users as board-only
solutions.