User Manual

10 APEX, ApexPro, and ApexPro CH Transmitter Programming Instructions Revision A - Draft 7
2001989-135
Introduction
NOTE
NOTENOTE
NOTE
To order other TTX number or channel labels or if items are missing
from your kit, contact Technical Support. (See page 78.)
Install the Software
Remove the Previous Version of Software
You must remove the previous version of configuration software before you
install the new version.
To remove software version 1B or earlier:
1. Select Start > Settings > Control Panel > Add/Remove Programs.
2. Select Apex & ApexPro Programming Box Software and select Add/
Remove.
3. Select Yes to confirm removal of this version of the software.
To remove software version 2A:
1. Select Start > Settings > Control Panel > Add/Remove Programs.
2. Select Apex & ApexPro Programming Box Software – Version 2A and
select Add/Remove.
3. Select Yes to confirm removal of this version of the software.
QTY
Programming Kit (Non-Japan)
PN 421733-003
1 Transmitter programming device
1 9-pin, 6-ft. RS232 serial cable
1 USB-to-serial cable
1 Software CD for configuration and transmitter
1 Channel 37 TTX number label set
1 APEX, ApexPro, and ApexPro CH Transmitter Programming Instructions
QTY
Programming Kit (Japan)
PN 421733-004
1 Transmitter programming device
1 9-pin, 6-ft. RS232 serial cable
1 USB-to-serial cable
1 Software CD for configuration and transmitter
1 ApexPro channel label set
1 ApexPro TTX number label set
1 PT Series TTX ID label set
1 APEX, ApexPro, and ApexPro CH Transmitter Programming Instructions –
Japan
Draft