User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Apex Transmitter
- 3 ApexPro CH Transmitter
- Program the Transmitter’s Basic Functions
- View Transmitter Diagnostics
- Update Transmitter Firmware
- ApexPro CH Appendices
- 4 ApexPro Transmitter
12 APEX, ApexPro, and ApexPro CH Transmitter Programming Instructions Revision A - Draft 7
2001989-135
Introduction
4. Insert the programming device connector into either of the transmitter’s
interface connector ports.
5. Turn the transmitter on:
For ApexPro and ApexPro CH, slide the battery cover over the
battery compartment. The LED lights will blink rapidly several
times and then slowly two times.
For Apex, close the battery cover. The LED lights will blink once and
then turn off.
Disconnect the Hardware
The transmitter should be disconnected and turned off when it is not in use.
1. Disconnect the transmitter from the programming device.
2. Turn off the transmitter by sliding the battery cover away from the
battery compartment. Doing this greatly extends the life of the batteries.
You may wish to remove the batteries and place them in a safe location.
3. (Optional) Disconnect the serial cable from the programming device and
from the PC.
ApexPro
Apex
ApexPro and ApexPro CH
Programming Device
010A
Transmitter’s interface port
Battery cover (on end)
ApexPro and
ApexPro CH
Apex
Apex
Transmitter
Programming Device
810A
Transmitter’s
interface port
Battery
cover
Apex
Draft