User Manual

Table Of Contents

14 APEX, ApexPro, and ApexPro CH Transmitter Programming Instructions Revision A - Draft 7

2001989-135

Introduction

Select a Hospital

In the Select Hospital window, select the correct hospital. This information is

used for reporting purposes. A separate report is created for each hospital.

(See “Generate Reports” on page 15.) In this window you can also establish

the settings for a new hospital, or change the settings for a hospital already

listed.

1. Select the hospital for where the transmitter is located (A).

2. After selecting a hospital, its name and location will be displayed on the

right side of the window (B). This information is used for reporting

purposes.

3. If the correct hospital is not listed, select <New Hospital> at the top of

the list (A). Enter the name and location information for that hospital on

the right side of the window. Select Save. Do not select OK yet.

4. If the name and location displayed are not correct, make the appropriate

changes and select Save (B).

5. If there is a hospital in the list which is no longer needed, select that

hospital and select the Delete button (B).

Table 2. Select Hospital window

Ref Definition

A List of hospitals

B Specific hospital name and location, with Save and Delete buttons

Option for displaying the Excel Transmitter report, with Browse button for changing the

location of the report

Option to view the Transmitter Report (Ref. C above) when exiting the Programming Box

application, with Browse button for changing the location of the report

E OK button to process the Select Hospital data

F Cancel button to exit the application

G File to be used to save data for the hospital(s) and transmitters (See step 7 below.)

A B

110A

Draft