User Manual

16 APEX, ApexPro, and ApexPro CH Transmitter Programming Instructions Revision A - Draft 7
2001989-135
Introduction
This is a section of a sample report:
To generate the Transmitter Report:
1. Verify that Microsoft Excel is installed on the computer.
2. Verify that the In-Band Noise Test has been performed per details in the
ApexPro Antenna System Tests and Troubleshooting Instructions
manual. Have test results available.
3. In the Select Hospital window, select Create Excel Transmitter Report.
4. Accept the Excel file location named by default as shown in the Excel File
box (Ref. C in Table 2 on page 14), or navigate to another location using
the Browse button (C).
5. Select Show Transmitter Report On Program Exit (D).
6. When done programming the transmitters, select Exit.
7. This window appears. Follow the instructions in Table 3 below.
Table 3. Select Channel Range window
Ref Definition
A Start Channel: Select the lowest channel to be used for analysis of the system
B End Channel: Select the highest channel to be used for analysis of the system
C
List of all frequencies that can not be used for transmitter signals.
Enter References D, E, F and G and then select Add.
D Type of signal blockage. Select Noise or Notch.
120A
A
F
E
125A
D
G
B
C
Draft