User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Apex Transmitter
- 3 ApexPro CH Transmitter
- Program the Transmitter’s Basic Functions
- View Transmitter Diagnostics
- Update Transmitter Firmware
- ApexPro CH Appendices
- 4 ApexPro Transmitter
Revision A - Draft 7 APEX, ApexPro, and ApexPro CH Transmitter Programming Instructions 19
2001989-135
Introduction
Program Other Transmitters
You can program more than one transmitter without disconnecting the
programming box.
If the next transmitter is the same type (both Apex or both ApexPro), you do
not need to exit the Apex & ApexPro Tx Config software:
1. Disconnect the current transmitter.
2. Connect the next transmitter.
3. The software will detect the new configuration for you to view or change.
If the next transmitter is a different type (Apex vs. ApexPro):
1. Exit the Apex & ApexPro Tx Config software.
2. Disconnect the current transmitter.
3. Connect the next transmitter.
4. Restart the Apex & ApexPro Tx Config software.
5. Select the new type of transmitter. The COM Port should remain the
same. Select OK.
6. Select the hospital and then OK.
7. The software will detect the new configuration for you to view or change.
Draft