User Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Apex Transmitter
- 3 ApexPro CH Transmitter
- Program the Transmitter’s Basic Functions
- View Transmitter Diagnostics
- Update Transmitter Firmware
- ApexPro CH Appendices
- 4 ApexPro Transmitter
Revision A - Draft 7 APEX, ApexPro, and ApexPro CH Transmitter Programming Instructions 9
2001989-135
Introduction
Install the Programming Device
Hardware Requirements for the Programming Device
IBM-compatible PC with the following:
Pentium (or better) processor
32 MB available memory
20 MB available hard drive space
Windows 2000, Service Pack 3 recommended
(Installer must have administrator rights to the PC on which the
system is being installed.)
NOTE
NOTENOTE
NOTE
MAY work on the following operating systems, but is not supported:
Windows 98
or
Windows XP
(Installer must have administrator rights to the PC on which the
system is being installed.)
or
Windows NT 4.0, Service Pack 6 or greater
(Service Pack 6 is provided on the installation CD. To perform this
upgrade, run sp6i386.exe from the CD.)
SVGA monitor with minimum resolution of 800 x 600
RS232C serial port or USB port
Apex, ApexPro, or ApexPro CH telemetry system transmitter
Two new AA alkaline batteries
Programming Kit (Only one is required no matter how many
transmitters are to be programmed.) See the following kit listings.
Draft