Step-by-step Instructions

4-4 Model 340 Telemetry System Revision A
2006899-001
Setup Procedures: Connecting the Receiver and Monitor
5. Connect the remaining ends of the cables to the color-coded
Ultrasound, ECG, and UA input connectors on the front or side panel of
the monitor.
Note: Model 118 shown.
Figure 4-4. Attaching the Monitor Interconnect Cables
6. Connect one end of the Remote Event Mark interconnect cable to the
connector on the receiver rear panel; connect the other end to the
Remote Marks connector on the rear or side panel of the monitor.
Note: Model 118 shown.
Figure 4-5. Attaching the Remote Mark Interconnect Cable