User's Manual

Collision Avoidance System: CAS-CAM/RF® Operating Instructions
Document Number: CAS-CAM_RF Operating Instructions (with FCC
precautions)_18June2010.doc
Page 102 of 126
Issue: E
16.3.4 Mobile Plant & Equipment (MPE) Diagnostic Table
Symptom Possible Cause Corrective Action
Mobile Plant &
Equipment (MPE) Unit
Dash Alarm not connected Check rear panel connection
Rotating Beacon not
connected
Check roof connection
Power indicator OFF
Loss of power Check in-line fuse
Check under-dash wiring /
connections
Check battery condition
Dash Alarm not connected Check rear panel connection
Rotating Beacon not
connected
Check roof mounted unit
connection
Loss of power Check in-line fuse
Check under-dash wiring /
connections
Check battery condition
HV not in gear Check HV gear status
Poor Antenna Connection Check antenna is firmly
attached & orientated upright.
Check for antenna damage &
replace if necessary – contact
Service Agent.
No Dash Alarms when
within HV (in gear), LV or
TS Detection Zone
Faulty Unit Replace with Spare Unit
Contact Service Agent for repair
“All of above” “All of above”
Blown lamp Replace lamp (12V, 55W)
Warning: isolate power from the
beacon by disconnecting the
external connector before
removing the lamp cover in
order to replace a globe, as the
beacon may start revolving
without warning when a Heavy
Vehicle is within the Light
Vehicle Detection Zone.
No external Rotating
Beacon Alarm when within
HV (In gear), LV or TS
Detection Zone
Faulty Unit Replace with Spare Unit
Contact Service Agent for repair
External Beacon not
rotating but lamp is ON
Faulty internal drive Replace with Spare Unit
Contact Service Agent for repair