User's Manual

Collision Avoidance System: CAS-CAM/RF® Operating Instructions
Document Number: CAS-CAM_RF Operating Instructions (with FCC
precautions)_18June2010.doc
Page 68 of 126
Issue: E
10.1.4 Changing Camera Settings
Programmable camera settings for each individual camera include: Colour, Mirror mode
and Camera Enable. These settings are not accessible by the operator and are
programmed at the time of installation using a laptop PC. These settings are saved during
power down and are automatically restored at power on.
10.1.5 Switching Cameras on Gearing
To configure the Display Unit to automatically switch to the FRONT or REAR camera when
engaging FORWARD or REVERSE gear, refer to section 13 as this function is only
programmable at the time of installation using a laptop PC.
At any time, other camera channels can be selected using the ⇧ , ⇩ arrow keys except
when RF detections have not been confirmed by pressing the “CONFIRM” key. Refer to
section 10.1.11.7 ‘Operator Confirmation of Alarms’ for details.
The Auto Cycle function is paused when camera switching is enabled on gear changes.
Press the ‘CYCLE’ key to resume Auto Cycling.
10.1.6 Switching Cameras on RF Detections
To configure the Display Unit to automatically switch to the FRONT or REAR camera on
FRONT or REAR RF detections, refer to section 13 as this function is only programmable
at the time of installation using a laptop PC.
At any time, other camera channels can be selected using the ⇧ , ⇩ arrow keys except
when RF detections have not been confirmed by pressing the “CONFIRM” key. Refer to
section 10.1.11.7 ‘Operator Confirmation of Alarms’ for details.
The Auto Cycle function is paused when camera switching is enabled on RF front / rear
detections. Press the ‘CYCLE’ key to resume Auto Cycling.
10.1.7 Auto Cycling Camera Channels
Enabling Auto Cycling
Camera Channels that are enabled can be cycled automatically at a nominated cycle time
(2s, 4s, 6s, 8s, 10s). This function is not programmable by the operator and is only
programmable at the time of installation using a laptop PC. This function setting is saved
during power down and is automatically restored at power on.
Pausing Auto Cycling to Study Camera View
1. When Auto Cycle is enabled and the active cameras are switching at the selected cycle
time, the Auto Cycle function can be paused at the current camera view by pressing
either of the ⇧ , ⇩ arrow keys.
2. Use the ⇧ , ⇩ arrow keys to switch between camera channels
Resuming Auto Cycling after Pausing