User's Manual

Collision Avoidance System: CAS-CAM/RF® Operating Instructions
Document Number: CAS-CAM_RF Operating Instructions (with FCC
precautions)_18June2010.doc
Page 80 of 126
Issue: E
11 HEAVY VEHICLE DISPLAY UNIT - MENU
FUNCTIONS
11.1 Boot-Up Screen
The following boot-up screen will appear for approximately 5 seconds after initial power
ON or after performing a Display Reset function (refer to section 10.1.9):
ADVANCED MINING TECHNOLOGIES
COLLISION AVOIDANCE SYSTEM
CAS-CAM/RF
®
SOFTXXXX-Y
ID 10003
SOFTXXXX-Y = Software Part Number - Issue
ID = Display Unit Identification (ID) Number (5 digits)
11.2 Default Screen
After initial power ON, the above boot-up screen will appear for approximately 5 seconds
after which the following DEFAULT screen will appear:
FRONT: LV 1
REAR: HV 1 LV 1 SO 2 PT 1 TS
DIM CAMERA 1 OFF
The RF Detection Status for the FRONT and REAR RF units will only appear if either of
these units are fitted to the Heavy Vehicle (CAS-RF
®
option) and there are valid detections
within the programmed Detection Zone(s). Otherwise, the top two lines of the screen will
remain blank to maximise the video display area.