User's Manual

Collision Avoidance System: CAS-CAM/RF® Operating Instructions
Document Number: CAS-CAM_RF Operating Instructions (with FCC
precautions)_18June2010.doc
Page 83 of 126
Issue: E
12.10 Heavy Vehicle Maintenance Mode
In order to disable alarms on all object types in the proximity of a Heavy Vehicle during
maintenance work, the Heavy Vehicle can be set to ‘Maintenance Mode’. This mode
disables all detections and alarms on both the Heavy Vehicle and all tagged objects within
the Heavy Vehicle Detection Zone(s). This mode is suited to a maintenance workshop
environment where normal CAS-RF
®
alarms may generate a high annoyance factor.
Refer to the CAS-CAM/RF
®
Installation Manual for programming details.
12.11 Heavy Vehicle Display Unit – Screen Power Down
12.11.1 Manual Mode
Refer to section 10.1.1 for details.
12.11.2 Automatic Mode
Refer to section 10.1.1 for details.
12.12 Real Time Clocks
The following CAS Units contain battery backed real time clocks, which can be used to
time & date stamp all RF detections and HV driver confirmation of alarms. This information
would be useful as a safety audit trail and is an optional feature.
• Heavy Vehicle Display Unit
• Light Vehicle Unit
• Stationary Object Unit
• Mobile Plant & Equipment Unit
• Test Station Unit
The programming of real-time clocks in all units is conducted at the time of installation
using laptop PC programming software. Refer to the CAS-CAM/RF
®
Installation Manual for
programming details.
12.13 Data Logging of Detections
All RF detections received by object types HV, LV, SO and TS can be logged to non-
volatile memory and are time and date stamped. This information would be useful as a
safety audit trail and is an optional feature.
Data is recovered via the RS-232 interface on the above mentioned objects using the
laptop Installer mode software. Refer to the CAS-CAM/RF
®
Installation Manual for
programming details.