User's Manual
Table Of Contents
- Slide Number 1
- Document Control
- Transport
- Storage
- Unpacking of Equipment
- Installation
- Slide Number 7
- Specialty Tools Required / Adhesives
- Specialty Tools Required / Adhesives
- Specialty Tools Required / Adhesives
- In Vehicle Unit (IVU) (PROD0842)
- Input Power & Signal Connections
- Input Power & Signal Connections
- IVU Mounting
- Mounting Locations & Cable Runs
- Mounting Locations & Cable Runs
- Light Vehicle
- Light Vehicle
- Haul Truck
- Haul Truck
- Slide Number 21
- Slide Number 22
- Slide Number 23
- Slide Number 24
- Heavy vehicle (excluding Haul Truck)
- Heavy vehicle (excluding Haul Truck)
- Display Unit (PROD0839)
- Display Unit (PROD0839)
- Display Unit (PROD0839)
- Display Unit (PROD0839)
- Display Unit (PROD0839)
- RF Installations
- RF Installations
- Upgrades
- Interconnections – 4CAM/4RF
- Interconnections – 4CAM/4RF
- Interconnections – 1CAM/1RF
- Interconnections – 1CAM/1RF
- Interconnections - LV
- Interconnections - LV
- Input Power & Signal Connections
- Slide Number 42
- Slide Number 43
- Deutsch Connector
- Input Power & Signal Connections
- Input Power & Signal Connections
- General Wiring Principles
- Antenna cable terminations
- Antenna cable terminations
- Antenna cable terminations
- Antenna cable terminations
- Antenna cable terminations
- Antenna cable terminations
- Testing Antenna cable terminations
- Testing Antenna cable terminations
- Antenna Cable Connection Security
- Configuration
- Configuration – Installation Measurements
- Configuration – Installation Measurements
- Configuration – Installation Measurements
- IVU Orientation
- IVU Orientation (Examples)
- Configuration
- Configuration
- Shovel with Heading
- Shovel with Heading Overview
- Primary IVU Configuration
- Primary IVU Configuration
- Secondary IVU Installation
- Secondary IVU Wiring
- Secondary IVU Configuration
- Shovel Heading Testing
- Shovel Heading Testing
- Configuration & Install Record
- Configuration & Install Record
- Configuration & Install Record
- Record Keeping
- Trouble Shooting
- Trouble Shooting
- Trouble Shooting
- Service and Maintenance
- Service and Maintenance
- Decommission
- Disposal
- Disclaimer
- Disclaimer
- Contact Details
- Slide Number 88
52
CAS GPS Installation Manual Rev G1
2/17/2016
Antenna cable terminations
5. Install cable assembly into body assembly so that inner ferrule portion slides
under braid. Push cable assembly forward until contact snaps into place in
insulator. The tip of the centre contact should be level with the face of the
connector.
6. Slide outer ferrule over braid and up against connector body. Crimp outer
ferrule using Die Set Cavity in table above.