User's Manual
Table Of Contents
- Slide Number 1
- Document Control
- Transport
- Storage
- Unpacking of Equipment
- Installation
- Slide Number 7
- Specialty Tools Required / Adhesives
- Specialty Tools Required / Adhesives
- Specialty Tools Required / Adhesives
- In Vehicle Unit (IVU) (PROD0842)
- Input Power & Signal Connections
- Input Power & Signal Connections
- IVU Mounting
- Mounting Locations & Cable Runs
- Mounting Locations & Cable Runs
- Light Vehicle
- Light Vehicle
- Haul Truck
- Haul Truck
- Slide Number 21
- Slide Number 22
- Slide Number 23
- Slide Number 24
- Heavy vehicle (excluding Haul Truck)
- Heavy vehicle (excluding Haul Truck)
- Display Unit (PROD0839)
- Display Unit (PROD0839)
- Display Unit (PROD0839)
- Display Unit (PROD0839)
- Display Unit (PROD0839)
- RF Installations
- RF Installations
- Upgrades
- Interconnections – 4CAM/4RF
- Interconnections – 4CAM/4RF
- Interconnections – 1CAM/1RF
- Interconnections – 1CAM/1RF
- Interconnections - LV
- Interconnections - LV
- Input Power & Signal Connections
- Slide Number 42
- Slide Number 43
- Deutsch Connector
- Input Power & Signal Connections
- Input Power & Signal Connections
- General Wiring Principles
- Antenna cable terminations
- Antenna cable terminations
- Antenna cable terminations
- Antenna cable terminations
- Antenna cable terminations
- Antenna cable terminations
- Testing Antenna cable terminations
- Testing Antenna cable terminations
- Antenna Cable Connection Security
- Configuration
- Configuration – Installation Measurements
- Configuration – Installation Measurements
- Configuration – Installation Measurements
- IVU Orientation
- IVU Orientation (Examples)
- Configuration
- Configuration
- Shovel with Heading
- Shovel with Heading Overview
- Primary IVU Configuration
- Primary IVU Configuration
- Secondary IVU Installation
- Secondary IVU Wiring
- Secondary IVU Configuration
- Shovel Heading Testing
- Shovel Heading Testing
- Configuration & Install Record
- Configuration & Install Record
- Configuration & Install Record
- Record Keeping
- Trouble Shooting
- Trouble Shooting
- Trouble Shooting
- Service and Maintenance
- Service and Maintenance
- Decommission
- Disposal
- Disclaimer
- Disclaimer
- Contact Details
- Slide Number 88
47
CAS GPS Installation Manual Rev G1
2/17/2016
General Wiring Principles
• Blanking plugs or caps are supplied and must be in place for all unused connectors
i.e. 24 way Deutsch Connector on the IVU for example
• All cable joins/splices should be soldered and heat shrink insulation applied
• All wires are to be labelled i.e. IGN, VIN+ ,GND , REV using the supplied labels
• DO NOT use clamp type splice devices to tee into vehicle wiring
• Crimp type ring terminals should be used for all terminal blocks
• All wiring should be run in the supplied flexible conduit along with the boot ends
also supplied in the kit