Digital Radiant Cooktop Owner's Manual

16
Glass Cooktop Cleaning
Digital Radiant Cooktop
Burned-on
residue
WARNING: DAMAGE to your glass surface may
occur if you use scrub pads other than BLUE Scotch-
Brite® Multi-Purpose No Scratch scrub sponges by
3M.
1. Allow the cooktop to cool.
2. Spread a few drops of Cerama Bryte® to the
entire burned residue area.
3. Using the scrub sponge, rub the residue
area, applying pressure as needed.
4. If any residue remains, repeat the steps listed
above as needed.
5. For additional protection, after all residue
has been removed, polish the entire surface
with Cerama Bryte® and a paper towel.
Normal daily
use cleaning
ONLY use the the recommended cleaning
cream, Cerama Bryte®, on the glass cooktop.
Other creams may not be as effective.
To maintain and protect the surface of your glass
cooktop, follow these steps:
1. Before you use the cooktop for the first time,
clean it with cleaning cream. This helps
protect the top and makes clean-up easier.
2. Daily use of the cooktop cleaning cream will
help keep the cooktop looking new.
3. Shake the cleaning cream well. Apply a few
drops of the cream directly to the cooktop.
4. Use a paper towel or sponge to clean the entire
cooktop surface.
NOTE: It is very important that you DO NOT heat
the cooktop until it has been cleaned thoroughly.
Clean your cooktop after
each spill.
Scotch-Brite
®
Multi-Purpose
No Scratch scrub sponge
Heavy,
burned-on
residue
WARNING: DAMAGE to your glass surface may
occur if you use scrub pads other than BLUE Scotch-
Brite® Multi-Purpose No Scratch scrub sponges by
3M.
1. Allow the cooktop to cool.
2. Spread a few drops of Cerama Bryte® to the
entire burned residue area.
3. Hold the razor scraper at approximately
a 45° angle against the glass surface and
scrape the soil. It will be necessary to apply
pressure to the razor scraper in order to
remove the residue.
4. Keep a small amount of cream on the residue
as you scrape.
5. After scraping with the razor scraper, use
the scrub sponge to remove any remaining
residue.
6. For additional protection, after all residue
has been removed, polish the entire surface
with Cerama Bryte® and a paper towel.
NOTE: Razor blade is packed inverted for safety
reasons. Prior to use, the blade must be rotated and
reinserted into slot. Do not use a dull or nicked blade.
The RAZOR SCRAPER is available
through our Parts Center. See
instructions under “To Order Parts”
section on next page.