Appliance Trim Kit User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 C400 Panel Controller Hardware
- General Information
- Genius Panel Controller (C400)
- Specifications
- Overview of Connections and Operational Elements
- VDC Power Supply (item 2, Figure 2-2)
- IF0 - RS-232, Non-isolated (item 3, Figure 2-2)
- Genius Bus Connector, Isolated (item 4, Figure 2-2)
- Mode Switch (item 6, Figure 2-2)
- Device Number Switches (item 8, Figure 2-2)
- Lithium Battery (item 7, Figure 2-2)
- Reset Button (item 9, Figure 2-2)
- Operating the C400 Controller
- Chapter 3 Quick Start
- Calling the Setup Program
- Language Selection
- Installation Menu
- Pull-Down Menus (Main Menu)
- Window Name
- Selection Windows
- Context-Sensitive Help Screens
- Screen Elements
- Connection to a GE Fanuc PLC via Genius
- Internal Connection
- Genius Internal Connection
- Picture 1
- Picture 2
- Picture 3
- Genius Device Connection
- Genius Internal Connection
- Internal Connection
- Picture for a Communications Error
- Picture Binding Overview
- Picture List Organization
- Chapter 4 Configuring Communication with the PLC
- Chapter 5 PCS Connection Editor
- Chapter 6 Demo Project
- Appendix A Cabling Information
- Appendix B Errors/Troubleshooting
- Index
6 - 30 PANELWARE MMI Application Manual for GE Fanuc Genius Protocol - June 1995 GFK-1115
6
Tip
If the field ends up in the wrong position in your picture, you can easily move it. First, move the
cursor into the field. With key combination Ctrl + Cursor key, the field can be moved to the
desired position.
4. Now, insert an input field into the picture in which a value
— data format: Word (signed) —
can be entered directly through the Panel Keyblock. This is done as follows:
● Position the cursor at (10,3).
● Press F2 Field.
● Select the Input Field option from the Field Class window and then press the ↵↵ key.
● From the Select Field Type window, choose the Input Word (signed) option, which
opens a window for defining the parameters for the selected input field:
● Enter
INP
_
INT
as the Destination Tagname and confirm the entry by pressing ↵↵. The
declaration of this address is done collectively for all variables in the connection editor.
● Do not change any more parameters. End the definition with F4 Accept. The Input
Word (signed) window is closed. The input field can now be seen in the picture: