Appliance Trim Kit User Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 C400 Panel Controller Hardware
- General Information
- Genius Panel Controller (C400)
- Specifications
- Overview of Connections and Operational Elements
- VDC Power Supply (item 2, Figure 2-2)
- IF0 - RS-232, Non-isolated (item 3, Figure 2-2)
- Genius Bus Connector, Isolated (item 4, Figure 2-2)
- Mode Switch (item 6, Figure 2-2)
- Device Number Switches (item 8, Figure 2-2)
- Lithium Battery (item 7, Figure 2-2)
- Reset Button (item 9, Figure 2-2)
- Operating the C400 Controller
- Chapter 3 Quick Start
- Calling the Setup Program
- Language Selection
- Installation Menu
- Pull-Down Menus (Main Menu)
- Window Name
- Selection Windows
- Context-Sensitive Help Screens
- Screen Elements
- Connection to a GE Fanuc PLC via Genius
- Internal Connection
- Genius Internal Connection
- Picture 1
- Picture 2
- Picture 3
- Genius Device Connection
- Genius Internal Connection
- Internal Connection
- Picture for a Communications Error
- Picture Binding Overview
- Picture List Organization
- Chapter 4 Configuring Communication with the PLC
- Chapter 5 PCS Connection Editor
- Chapter 6 Demo Project
- Appendix A Cabling Information
- Appendix B Errors/Troubleshooting
- Index
6 - 64 PANELWARE MMI Application Manual for GE Fanuc Genius Protocol - June 1995 GFK-1115
6
Compiling the Project
To download a project to the Panel, it must first be compiled. Only a project that is loaded (project
name in the title bar) can be compiled. Start the compilation by accessing the project compiler,
either via the Compile menu option in the Utilities menu, or by pressing the key combination
Ctrl + Q.
The progress of the compilation procedure is shown in the Project Compiler window. If the
project is successfully compiled (translated), the following message appears:
The amount of memory used in the user bank (FlashPROM in the Panel) is also shown after a
successful compilation. See the PANELWARE™ Hardware Installation User’s Manual (GFK-
0848) for more information.
Pressing Esc closes the window and returns you to the main menu.
Errors
During the compilation, error messages can appear in the Project Compiler window.
If you receive an error message, refer to Appendix C of the PANELWARE™ Configuration
Software Reference Manual (GFK-0849).