Wine Chiller, Wine Reserve and Beverage Center Installation Instructions

Design Guide
THE INSTALLATION SPACE
The cutout depth should be 24″
The cutout dimensions shown allow for a full door
swing and access to the pull-out racks when installed
as a built-in in standard 24″ deep cabinets.
• The wine chiller, wine reserve and beverage center
can be installed freestanding.
• If installing between frameless cabinets, a 1/2″ wide
filler strip or side panel may be needed on hinge
side. The filler strip will act as a spacer between the
case and adjacent cabinet door swing. The width
of the opening must include the filler panels.
NOTE: The door should protrude 1″ beyond the
surrounding cabinets.
Additional Specifications
• A 120 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install a
properly grounded 3-prong electrical receptacle
recessed into the back wall as shown. Electrical must
be located on rear wall as shown. NOTE: GFI
(ground fault interrupter) is not recommended.
PRODUCT CLEARANCES
The wine chiller, wine reserve and beverage center is
factory set for a 110° door swing.
When installed in a corner:
• Allow 4″ min. clearance on the hinge side for the
90° door swing and to allow racks to slide out.
• Allow 10″ minimum clearance on the hinge side
for a full 110° door swing.
• The door swing is reversible on all models. If
desired, change the door swing before installation.
Choose the location:
• These products may be closed in on the top and
three sides as long as the front is unobstructed for
air circulation and proper access to the door.
• Do not install these products where the temperature
will go below 55°F (13°C) or above 90°F (32°C).
• Do not install where it will be subject to direct
sunlight, heat or moisture.
• These products are not designed to be stacked one
over the other.
Black or Stainless Steel Toekick Options
• These products are shipped with a black toekick
installed. An optional stainless steel toekick is also
supplied with each product. For shipping purposes,
the stainless steel toekick is secured to the back
of the unit.
3
90° Door Swing
SIDE-BY-SIDE INSTALLATIONS
Increase storage capacity by installing two Monogram
beverage centers, wine chillers or wine reserves together.
Or, for a complete refreshment center, install any two
of these units together.
• A side-by-side installation requires at least a 47-1/2″
wide opening. No trim kits required.
• Products must operate from separate, properly
grounded receptacles.
10" Minimum
to Wall
110°
21-5/8"
23-5/8"
4" Minimum
to Wall
90°
34-1/2"-35"
24"
47-1/2" Min.
1-1/2"
9"
10-1/2"
9"
10-1/2"
14"
15"
Locate
Outlet
23-3/4"
34-1/2"
23-3/4"
Locate
Outlet
34-1/2"-35"
24"
23-3/4" Min.
9" Max.
10-1/2"
1-1/2"
NOTE:
Handle and
handle standoff
depth is 1-3/4″