Installation instructions

19
Installation Instructions
INSTALLATION—RECIRCULATING
INSTALL FILTERS
IMPORTANT: Check to be sure that the main
ON/OFF switch next to the motor is in the ON
position.
Charcoal filter
• Install the black charcoal filter into the center
opening. Secure the filter with thumbscrews on
each side.
Metal filter
• Tip the filter into the left or right side of the
opening. Lift the filter to the opposite side and into
the filter lock.
• To remove the filter, pull the filter lock downward.
10
FINALIZE INSTALLATION
• Remove all tape and packing material.
• Refer to the Owner’s Manual for operating
instructions.
11
INSTALL DUCT COVERS
• Place the decorative duct
covers on top of the hood.
NOTE: The inside piece has
holes on one end intended for
use when the hood is installed
for recirculating purposes.
Be sure the vented end is at
the top; the vent holes will
be visible in this installation.
The inside duct piece must slip
into the folded ends on the outer
section.
• Extend the inner duct upward to the ceiling
bracket.
• Secure duct cover to ceiling bracket with 2 screws.
9
Mounting
screw holes
Vent holes
Duct cover
support bracket
Upper
duct cover
Lower duct
cover
Lower duct
cover seat
Filter Lock
Duct cover
support bracket