User Manual

/RZVHWWLQJDGMXVWPHQWVPXVWEHPDGHZLWKRWKHUEXUQHUVLQ
operation on a medium setting. This procedure prevents the
ORZÀDPHIURPEHLQJVHWWRRORZUHVXOWLQJLQWKHÀDPHEHLQJ
extinguished when other burners are turned on.
A. Turn on all surface burners to medium setting.
% 7XUQWKHNQRERQWKHEXUQHUEHLQJDGMXVWHGWR³/2´
& 5HPRYHWKHNQREDQGLQVHUWDVPDOOÀDWEODGHVFUHZGULYHU
into the valve shaft and/or side adjustment screw(s) as
shown and turn clockwise to fully tighten down the bypass
screw(s). Repeat for all valves.
' ,IÀDPHDSSHDUVWRRORZRUXQVWDEOHVORZO\WXUQE\SDVVVFUHZ
FRXQWHUFORFNZLVHXQWLODVWDEOHÀDPHH[LVWVIRUHDFKEXUQHU
Remember, other burners must be turned on to medium.
SPECIALTY BURNERS
Dual Oval Burner – This burner should be properly adjusted
with both bypass screws completely screwed in.
Multi-Ring Burner±7KHRXWHUULQJRIÀDPHVVKRXOGEH
DGMXVWHGZLWKWKHNQREDWWKH0('
by adjusting the set screw in the
FHQWHUYDOYHVKDIW7KHÀDPHVVKRXOG
be adjusted so that they barely curl
over the top edge of the burner cap.
7KHFHQWHUULQJRIÀDPHVVKRXOGEH
DGMXVWHGZLWKWKHNQREDWWKH/2
setting by adjusting the set screw to
the right of the valve shaft.
( $GGLWLRQDOO\IRUHDFKEXUQHUEHLQJDGMXVWHGTXLFNO\RSHQ
DQGFORVHWKHRYHQGRRUZKLOHREVHUYLQJÀDPH,IÀDPHLV
extinguished, continue adjusting bypass screw for a larger
ÀDPH5HSHDWGRRURSHQLQJVXQWLOÀDPHLVVWDEOH
F. Replace the knob.
CONVERTING THE OVEN BURNERS
ADDITIONAL INFORMATION
BAKE BURNER ORIFICE
1. Remove oven racks, door and oven bottom. Remove the
1/4” hex screws securing the bake burner.
 7KHEDNHEXUQHURUL¿FHLVRQWKHJDVYDOYHORFDWHGEHKLQG
WKHZDUPLQJGUDZHU/LIWWKHEXUQHURIIWKHRUL¿FHDQGDSSO\
D´VRFNHWRQDQH[WHQVLRQWRWKHKH[EDVHRIWKHRUL¿FH
RQWKHJDVYDOYH/RRVHQWKHRUL¿FHE\WXUQLQJFRXQWHU
clockwise and remove.
 6HOHFWWKHSURSDQHEDNHRUL¿FHIURPWKHNLWDQGLQVWDOOLWRQ
the gas valve. Tighten until snug.
BROIL BURNER ORIFICE
1. Remove the 1/4” hex screw securing the broil burner and
DOORZLWWRKDQJGRZQIUHHRIWKHEURLORUL¿FH
 $SSO\D´ZUHQFKWRWKHKH[EDVHRIWKHRUL¿FH/RRVHQ
WKHRUL¿FHE\WXUQLQJFRXQWHUFORFNZLVHDQGUHPRYH
 6HOHFWWKHSURSDQHEURLORUL¿FHIURPWKHNLWDQGLQVWDOOLWRQ
the broil elbow. Tighten until snug.
 5HSODFHWKHEURLOEXUQHURYHUWKHRUL¿FHDQGUHSODFHWKH
screw securing the burner.
/LIW
Burner
%DNH%XUQHU2UL¿FH
ADJUSTING AIR SHUTTER SETTINGS
FOR OVEN BURNERS
ADJUSTING LOW FLAME SETTING
ON COOKTOP BURNERS
 :LWKD3KLOOLSVKHDGVFUHZGULYHUORRVHQWKHVFUHZV
securing the air shutter on the bake burner. Adjust the air
shutter to fully open.
2. Turn on the gas.
3. Turn on the electricity.
4. Reinstall the oven door.
5. Turn on the bake burner.
2YHQEXUQHUÀDPHPXVWEHREVHUYHGZLWKWKHGRRUFORVHG
WRSURSHUO\FKHFNÀDPHFKDUDFWHULVWLFV
 $V\RXZDWFKWKHÀDPHZLWKWKHRYHQGRRUFORVHGFKHFN
the following through the oven door window.
 D,IWKHÀDPHVDUH\HOORZRSHQWKHDLUVKXWWHUPRUH
 E,IWKHÀDPHVEORZDZD\RUÀXWWHUIURPWKHEXUQHUFORVH
the air shutter slightly.
7. Turn bake burner off and repeat with broil burner.
 &KHFNLQJWKHÀDPHVL]H
It should be approximately 1/2”
to 3/4” long for the bake and broil
burners.
The combustion quality of the
EXUQHUÀDPHVQHHGVWREH
determined visually.
127(,IEXUQHUÀDPHVORRNOLNH$IXUWKHUDLUVKXWWHU
DGMXVWPHQWWRWKHEDNHEXQHULVUHTXLUHG1RUPDO
EXUQHUÀDPHVVKRXOGORRNOLNH%RU&GHSHQGLQJ
RQWKHW\SHRIJDV\RXXVH:LWKSURSDQHJDVVRPH
\HOORZWLSSLQJRQWKHRXWHUFRQHVLVQRUPDO
)RUHLJQSDUWLFOHVLQWKHJDVOLQHPD\FDXVHDQRUDQJHÀDPHDW
¿UVWEXWWKLVZLOOVRRQGLVDSSHDU
9. When all adjustments are made and the results are
satisfactory:
a. Retighten the air shutter screws.
b. Replace the oven bottom.
c. Replace the storage drawer.
PROPANE CONVERSION INSTRUCTIONS
31-10993-2 03-17 GEA
PGB940
NOTICE:
This product cannot be converted to propane by adjusting
WKHRYHQRUL¿FHV7KHRUL¿FHVPXVWEHUHSODFHGIRUSURSDQH
NOTICE:
2QFHWKHFRQYHUVLRQLVFRPSOHWHDQGFRQ¿UPHG¿OORXW
WKHSURSDQHVWLFNHUDQGLQFOXGH\RXUQDPHRUJDQL]DWLRQ
and date conversion was made. Apply the sticker to
the range near the regulator to alert others in the future
that this appliance has been converted to propane. If
converting back to natural gas from propane, please
remove the sticker so others know the appliance is set to
use natural gas.
NOTICE:
6DYHWKHVHRUL¿FHVIRUIXWXUHFRQYHUVLRQEDFNWRQDWXUDOJDV
Screw
Air shutter
WARNING
If you attempt to measure the inner cone
RIWKHÀDPHSOHDVHXVHFDXWLRQEXUQVFRXOGUHVXOW
(A) Yellow flames:
Further Adjustment
Required
(B) Yellow tips on
outer cones:
Normal for Propane Gas
(C) Soft blue flames:
Normal for Natural Gas
BURNER OUTPUT RATINGS: BTU/HR
NG (Natural) Gas 5” W.C.P.
BURNER
BTU
RATE
ORIFICE
SIZE (mm) COLOR MARKING
/) 20,000 1$
/) 1$ 0.043” (1.09) Blue/White 1
/) 1$ 0.043” (1.09) Blue/White 1
/) 1$ 0.043” (1.09) Blue/White 1
/)& 1$ 0.025” (0.63) 1RQH 1
RF 18,000 0.078” (1.98) 3XUSOH 1
/5 5,000 0.040” (1.01) :KLWH3XUSOH 1
RR 9,500 0.053” (1.36) *UHHQ 1
C 10,000
C1 1$ 0.055” (1.41) Yellow 1
C2 1$ 0.053” (1.36) *UHHQ 1
%$.( 16,000 0.070” (1.78) 1RQH 50
%52,/ 16,500 0.051” (1.29) *UHHQ<HOORZ
4W\
1
198
III
Denotes 1.98mm Orifice size opening
Denotes Natural Gas
N
Flames
Burner Cap
7KHDLUVKXWWHUVVKRXOGEHWXUQHGWRWKHPDUNHGVHWWLQJV1*RU
propane or set according to the following table.
BURNER
AIR SHUTTER
SETTING FOR PROPANE
AIR SHUTTER
SETTING FOR NG
Oven Broil
Burner
1/4” (two places) 7/16” (two places)
Oven Bake
Burner
Full open 13/32”
Oven light
%URLORUL¿FHV
Broil burner
assembly
SPECIAL NOTE:
7RFRQYHUWWKHRYHQEDFNWRQDWXUDOJDVUHYHUVHWKH
LQVWUXFWLRQVJLYHQLQPDNLQJSURSDQHDGMXVWPHQWV
Adjustment screws for
dual oval burner only
Adjustment screws for
multi-ring burner only
Adjustment screw for
center ring
Adjustment screw for
outer ring
Adjustment
screw for
2 oval rings
Adjustment
screw for
center ring
Center adjustment screw
only for all other burners.