Installation Guide

49-80516-4

Installation Instructions

INSTALLING THE COOKTOP

INSTALLING THE BLOWER PLENUM

TO THE COOKTOP

Slide the plenum, with the blower opening on the left, into

the opening in the bottom of the cooktop. Push up on the

plenum until the stops on the plenum contact the bottom of

the cooktop, and snap the plenum into place. (You may have

to move the plenum back and forth to work it into place.)

Secure the plenum to the bottom of the cooktop, on each

side, using the four (4) screws provided. Further secure the

plenum to the cooktop, from the top side, using the two

screws (2) provided.

INSTALLING THE BLOWER

TO THE PLENUM

Orient the blower discharge opening to match the ductwork

in Steps 5 and 6. Slide the four threaded studs on the side

of the blower housing into the four holes on the side of the

plenum.

NOTE: See Step 13 for installing the transition duct to the

blower. It may be easier to install the transition duct to the

blower before installing the blower to the plenum.

From the vent opening in the top of the cooktop, fasten the

blower assembly securely to the plenum with four (4) nuts.

Install 4 screws

Install 2 screws

4 Nuts

(

/16”

socket

required)

INSTALLATION INSTRUCTIONS