Installation Manual

18
Installation Instructions
REVERSING THE DOOR (OPTIONAL)
1
Open the door approximately 130°. With a putty
knife, remove the 4 plastic caps located along the
left side of the front panel and set them aside.
2
Remove the bottom screw from each hinge (right
side) and partially insert them into each top hinge
hole on the left side.
NOTE: All 4 front panel hinge screws will now be
in the top hinge holes - 2 on the left and 2 on the
right.
3
Loosen each top hinge screw on right side.
Remove the door and place it on a protective flat
surface to avoid any damage.
Plastic Cap (4)
Left side of
front panel
Loosen each
top hinge screw
on right side
Blind
plate
Strike
plate
Hinge
screws
Hinge
Plastic
Caps
Inner door
Outer door
Inside screws
Inside
screws
Door
Hinges
Choose the REVERSING THE DOOR
instructions
A
or
B
for your model.
A
MODELS WITHOUT FABRIC REFRESH
FEATURE
A
MODELS WITHOUT FABRIC REFRESH
FEATURE (cont.)
4
Remove both the blind plate and the strike plate and
install them in the opposite positions.
5
Remove the 2 hinge plastic caps and 4 hinge screws.
6
Remove the 8 inside screws. Lift the inner door
upwards using a flat blade screwdriver. Remove the
2 door hinges.