Quick Specs

PEB7227ANDD
GE Profile
™
Series 2.2 Cu. Ft. Built-In Sensor Microwave Oven
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
For answers to your Monogram, GE Café
™
Series, GE Profile
™
Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center
®
Service, 800.626.2000.
Specification Revised 8/19
Listed by
Underwriters
Laboratories
Cabinet overlap requirements 30" 27"
A - Overlap of trim kit over top of cabinet 1" 1"
B - Overlap of trim kit over bottom of cabinet 1-1/8" 1-1/8"
C - Overlap of trim kit over sides of cabinet 2-1/8" 5/8"
Note:
Allow an additional inch
of clearance beyond trim
frame on all sides
Accessory Trim Kits Z Max Height Trim Kits
30" 29-3/4" 19" JX2130SLSS
27" 26-7/8" 19" JX2127SLSS
18-7/8"
Z
B
A
C
16-3/4" ± 1/8"
25-1/2" up to 25-5/8"
22" min.
receptacle
in cabinet
19-1/2" min.
receptacle
outside
cabinet
Base Pan
Trim
Kit
Cabinet overlap requirements 30" 27"
A - Overlap of trim kit over top of cabinet 1" 1"
B - Overlap of trim kit over bottom of cabinet 1-1/8" 1-1/8"
C - Overlap of trim kit over sides of cabinet 2-1/8" 5/8"
Note:
Allow an additional inch
of clearance beyond trim
frame on all sides
Accessory Trim Kits Z Max Height Trim Kits
30" 29-3/4" 19" JX2130SLSS
27" 26-7/8" 19" JX2127SLSS
18-7/8"
Z
B
A
C
16-3/4" ± 1/8"
25-1/2" up to 25-5/8"
22" min.
receptacle
in cabinet
19-1/2" min.
receptacle
outside
cabinet
Base Pan
Trim
Kit
EXTERIOR DIMENSIONS (IN INCHES)
W x H x D 24 1/8" x 14" x 19 3/4"
COLOR TRIM KIT SIZE Z MAX. HEIGHT
Stainless Steel JX7227SLSS 27" 26 7/8" 18 7/8"
Slate JX7227ELES 27" 26 7/8" 18 7/8"
Stainless Steel JX7230SLSS 30" 29 3/4" 18 7/8"
Slate JX7230ELES 30" 2 9 3/4" 18 7/8"
Black Stainless JX7227BLTS 27" 26 7/8" 18 7/8"
Black Slate JX7227FMDS 27" 26 7/8" 18 7/8"
Black Stainless JX7230BLTS 30" 29 3/4" 18 7/8"
Black Slate JX7230FMDS 30" 29 3/4" 18 7/8"
ACCESSORY TRIM KITS FOR GE MICROWAVE OVENS
(AVAILABLE AT ADDITIONAL COST)
For a custom built-in appearance, these kits allow built-in
installation of the microwave oven into a wall or cabinet alone and
are U.L. approved for installation over a GE single electric wall
oven. These kits should not be installed over a gas wall oven.
NOTE: 120V, 60-cycle, grounded power receptacle location
optional on back within cabinet opening.
INSTALLATION INFORMATION: This information is not
intended to be used for installing unit described. Before installing,
consult installation instructions packed with product/kit for
current dimensional data. For ADA compliance, the microwave
must be installed no higher than 36 1/4".
30" cabinet 30" cabinet
Cabinet door
or other
obstruction
Width of microwave including trim kit
1/4"
This gap needs
to be at least 3/4"
NOTE: Allow an additional inch of clearance beyond trim
kit frame on all sides to prevent the trim kit from blocking
any outside adjoining cabinets/obstructions. Reference
below drawing.