Installation Sheet

30
49-80516-4
Installation Instructions
FINAL ASSEMBLY
19
ASSEMBLE BURNERS, CHECK IGNITION
Assemble burner as shown.
CAUTION: Do not operate the burner without all
burner parts in place.
Place the burner heads on the burner bases matching the
letters. Place the caps on the heads. Make sure that the
heads and caps are placed on the correct size burner. The
burner heads and burner
bases are labeled A, B and C
to aid reassembly. There is one
small (A), two medium (B) and
one large (C) head and cap.
Make sure the notch in the
burner head is positioned
toward the electrode. Rotate
the burner head around the burner base until it is level and
securely seated.
Place the grates over the burners.
Check for proper ignition:
• Push in one control knob and turn to LITE position.
• The igniter will spark and the burner will light; the igniter
will cease sparking when the burner is lit.
• First test may require some time, while air is flushed out of
the gas line.
• Check to determine if your burner flames are normal. If
your burner flames look like A, turn off the burner and
make sure all parts are assembled correctly. Reassemble
and check. Normal burner flames should look like B or C
depending on the type of gas you use. With LP gas, some
yellow tipping on the outer cones is normal.
• Turn knob to OFF.
• Repeat the procedure for each burner.
Grate
Burner head
Burner cap
Electrode
Burner base
Curved side
toward the
center
Medium
Head
and Cap
Medium
Head
and Cap
Front of Cooktop
Small
Head
and Cap
Large
Head
and Cap
A–Yellow flames
Call for service
B–Yellow tips
on outer cones
Normal for LP gas
C–Soft blue
flames Normal
for natural gas
INSTALLATION INSTRUCTIONS