Specification

DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
PHP9030DJ
GE Profile
™
Series 30" Built-In Touch-Control Induction Cooktop
For answers to your Monogram, GE Café
™
Series, GE Profile
™
Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center
®
Service, 800.626.2000.
Specification Revised 1/19
ADA
COMPLIANT
Listed by
Underwriters
Laboratories
To insure accuracy, it is best to make a
template when cutting the opening in the counter
Electrical junction box 16" MIN.
below countertop
Cooktop
29-3/4"
20-7/8"
19-1/4"
28"
19-5/8"
to 19-3/4"
2-1/2" MIN.
Required
28-1/2" to
28-5/8"
1-3/4" MIN.
to rear wall
PHP9030DJ
4-5/8" at baffle near center of
unit (except when installed
above an approved wall oven)
and
3-1/4" at rear of air intake
13" MAX. depth of unprotected
overhead cabinets (when no
hood or microwave is installed)
30" MIN. from countertop to
unprotected cabinet (when
no hood or microwave is
installed)
2" MIN. clearance
to side wall from cut-out
on both sides of cooktop
15" MIN. height from countertop
to nearest cabinet (including
light rails) on both sides of
cooktop
IMPORTANT: Requires a 3" free area between
the bottom of the cooktop to any combustible
material, i.e., shelving. Free area not required when
installing wall oven underneath cooktop. Refer to
installation instructions. Requires a 15" minimum
from cooktop to adjacent overhead cabinets. Units
are furnished with a 48" flexible armored cable.
NOTE: 30" induction cooktops are approved for
use over select GE 27" and GE 30" Single Wall
Ovens and Warming Drawers. Refer to cooktop and
wall oven/warming drawer installation instructions
packed with product for current dimensional
data. If installed with a GE Telescopic Downdraft
System, consult both the cooktop and downdraft
installation instructions packed with product
before installing. Cooktop gas/electric supply
may need to be re-routed to install downdraft.
The countertop cutout requires 23-1/2” minimum
flat countertop surface and 25” minimum total
countertop depth. In addition, other clearances
to front edge of the countertop must be considered.
Before installing, consult installation instructions
packed with product for current dimensional data.
CUTOUT FILLER TRIM KIT: A filler trim kit
is available for use if your countertop cutout is
larger than the dimension shown, up to 29-13/16" x
20-7/16". Order JXTR32B for black or JXTR32W
for white, to reduce the cutout opening for
installation of this cooktop. These kits may be
ordered from your GE Appliances Dealer.
APPROXIMATE COOKING DIMENSIONS
KW RATING
240V 7.4
208V 6.4
AMPERAGE
240V 40 Amps
†
208V 40 Amps
†
†
NOTE: Check local
codes for required
breaker size.
2-1/2" MIN
From front edge
of countertop to front
edge of cooktop cutout
31-1/4" MIN
From top surface
of countertop to
top surface of
wall oven support
platform
INSTALLATION ABOVE A WALL OVEN
INSTALLATION ABOVE A WALL OVEN