Specifications

Specification Created 1/15
For answers to your Monogram,
®
GE Profile
™
or GE
®
appliance questions, visit our website
at geappliances.com or call GE Answer Center
®
service, 800.626.2000.
Listed by
Underwriters
Laboratories
To insure accuracy, it is best to make a
template when cutting the opening in the counter
Electrical junction box 16" MIN.
below countertop
Cooktop
29-7/8"
21-1/2"
19-1/4"
28"
19-5/8"
to 19-3/4"
2-1/2" MIN.
Required
28-1/2" to
28-5/8"
1-3/4" MIN.
to rear wall
PHP9030SJ
4-5/8" at baffle near center
ofunit (except when installed
above an approved wall
oven) and 3-1/4" at rear
of air intake
13" MAX. depth of unprotected
overhead cabinets (when no
hood or microwave is installed)
30" MIN. from countertop to
unprotected cabinet (when
no hood or microwave is
installed)
2" MIN. clearance
to side wall from cut-out
on both sides of cooktop
15" MIN. height from countertop
to nearest cabinet (including
light rails) on both sides of
cooktop
Important: Requires a 5" free area between
the bottom of the cooktop to any combustible
material, i.e., shelving. Free area not required
when installing wall oven underneath cooktop.
Refer to installation instructions. Requires a 15"
minimum from cooktop to adjacent overhead
cabinets. Units are furnished with a 48" flexible
armored cable.
note: 30" induction cooktops are approved
for use over select GE 27" and GE 30" Single
Wall Ovens and Warming Drawers. Refer
to cooktop and wall oven/warming drawer
installation instructions packed with product for
current dimensional data. If installed with a GE
Telescopic Downdraft System, consult both the
cooktop and downdraft installation instructions
packed with product before installing. Cooktop
gas/electric supply may need to be re-routed to
install downdraft. The countertop cutout requires
23-1/2" minimum flat countertop surface and 25"
minimum total countertop depth. In addition,
other clearances to front edge of the countertop
must be considered. Before installing, consult
installation instructions packed with product for
current dimensional data.
Cutout fIller trIm kIt: A filler trim kit
is available for use if your countertop cutout
is larger than the dimension shown, up to
29-13/16" x 20-7/16". Order JXTR32B for black or
JXTR32W for white, to reduce the cutout opening
for installation of this cooktop. These kits may be
ordered from your GE Dealer.
DImensIons anD InstallatIon InformatIon (In InChes)
php9030sJ
GE Profile
™
Series 30" Built-In Touch Control Induction Cooktop
KW Rating
240V 7.3
208V 6.4
Amperage
240V 30.8 Amps
†
208V 30.8 Amps
†
†
Note: Check local codes
for required breaker size
approxImate CookIng DImensIons