Use and Care Manual

12 49-2000974 Rev. 1
USING THE COOKTOP: Custom Settings
Custom Settings
1. PressandholdAll Off pad for 3 seconds, then
immediately press and hold the Timer Select pad for
3 seconds to enter custom settings. Those two pads
must be pressed within 30 seconds. Any other pad
will cancel mode.
2. “C--”appearsondisplay.Tonavigatethroughthe
Custom Settings, use the Ʌ (up)or V (down)pads.If
Ʌ (up)isselectedthedisplaycyclestartsat“C01”.If
V (down)isselected,thedisplaycyclestartsat“C62”.
3. To activate a new Custom Setting the user will
touch and hold the Timer Select pad for 3 sec.
OnlyONEoftheCustomSettingChoicescanbe
activatedforeachCustomSetting.Thered“On”
LEDwillturnonandasoundwillgooffonceanew
custom setting is activated.
4. The cooktop will exit Custom Settings if it is inactive
for 3 minutes.
5. To exit Custom Settings and save any changes, touch
and hold the All Off pad for 3 seconds.
* Options in grey are default settings
Custom Settings Chart
Custom Settings Custom Setting Choices
C0 (Factory Settings) C01 - FactoryReset(Clearscustomizedsettingsandrestoresdefaults)
C02 - Customsettingsactivated(Notvisibleunlessanyothercustomsettingisselected.And
automaticallyonwhenanyothercustomsettingisselected.Notselectablebyuser.)
C1 (Control Lock) C11 - StandardLock(ie;Onlyonwhenlockbuttonpressedfor3seconds.)Ifusingatimer,
ControlLockisunavailable.
C12 - AutoLock(ie;Engagesaftercooktophasbeeninstandbymodefor10minutes.)Theunitshouldbe
completelyofftogointoAutoLock.
C2 (LED light level) C21 - Full illumination
C22 - Medium illumination
C23 - Lowestillumination
C3 (Button Loudness) C31 - Allsoundsactivatedat100%(Foralarmsounds,100%=Whateverlevelissetinc4.)
C32 - Buttonsoundlevelreducedby50%,Alarmsoundsat100%
C33 - Buttonsoundsdeactivated,Alarmsoundsactivatedat100%
C4 (Timer Alarm Loudness) C41 - High
C42 - Low
C5 (Timer Alarm Duration) C51 - Indefinite(ie;alarmcontinuesuntilcancelledbyuser).
C52 - Alarm sounds for 60 seconds.
C53 - Alarm sounds for 30 seconds.
C54 - Alarm sounds for 15 seconds.
C6 (Timer Mode) C61 - SingleKitchenTime(Independentofelements.)
C62 - Multi-Timer(Tiedtoeachelement.)