Owners Manual and Installation Instructions

49-2000768 Rev. 0 13
PREPARING CABINET: BELOW WALL OVENS
INSTALLATION BELOW A SINGLE OVEN
INSTALLATION BELOW A DOUBLE OVEN
Ŷ When installed, the front face of the warming
drawer will be nearly flush with cabinetry doors or
drawer fronts.
Ŷ 'UDZHURYHUODSVZLOOFRQFHDOFXWHGJHVRQDOOVLGHV
of the opening.
The rough opening for the drawer must be:
 ²'HSWK
1
/2” minimum from inside back to front
of cabinet frame.
 ²:LGWK
1
/2” for 27” wide models
28
1
/2” for 30” wide models.
 ²+HLJKW
1
/4”
²$OORZ´PLQLPXPEHWZHHQRYHQDQGGUDZHU
cutouts for clearance of overlaps
NOTE: If you are installing in frameless cabinets, it
may be necessary to install 1/2” wide cleats to accept
drawer mounting screws. See drawer to find exact
locations of mounting screws.
When installed under a wall oven:
Warming drawers are suitable for installation below
only certain specified wall oven models. See the
label attached to the top of the warming drawer for
suitable models.
NOTE: Electrical receptacle can be installed as shown
IRUFRXQWHUWRSLQVWDOODWLRQV'RQRWLQVWDOOUHFHSWDFOH
above the top of the warming drawer cutout.
INSTALLATION INSTRUCTIONS
Installation Instructions
23
1
/2”
Min.
2x2 or 2x4
anti-tip block
against rear
wall 9” from
floor to bottom
of block
1" Min. above toekick
or adjust to oven
installation height
A
2" Min.
Allow 5/8”
overlap on
all sides
%
Oven
cutout
NOTE: Additional clearance between cutouts may be
required. Check to be sure that oven supports above
the warming drawer location do not obstruct the
required interior 23
1
/2” depth and 9
1
/4” height.
Dimension A Dimension B
27" Drawer 25
1
/2” 26
3
/4”
30" Drawer 28
1
/2” 29
3
/4”
9"
9
1
/4"
10
1
/2"
23
1
/4"
NOTE: Additional clearance between
cutouts may be required. Check to be sure
that oven supports above the warming
drawer location do not obstruct the required
interior 23
1
/2” depth and 9
1
/4” height.
2" Min
1" Min. above
toekick
2x2 or 2x4
anti-tip block
against rear wall
9” from floor to
bottom of block
23
1
/2”
Min.
Allow 5/8” overlap
on all sides
A
9"
9
1
/4"
%
10
1
/2"
23
1
/4"
Oven
cutout