Installation Guide

31-11007-2 7
Installation Instructions
PREPARE HOOD FOR INSTALLATION
Removethegreaselterfromthe
unitandsetaside.Thegreaselter
isremovedbypressingthehandle
infrontofthelter.Whenreplacing,
makesurethatthelterisproperly
positionedwiththehandlesinfront
andvisible.
Vented Installations
1.Securelypressthedamperontopoftheexhaust
opening.Checkthatthedamperopensfreely.
2.Removeandproperlydiscardtheprotectiveplastic
wrappingfromthehoodandgreaselter.
3.GotoMount the Glass Range Hood section.
Non-vented (ductless) Installations
NOTE: Arecirculationduct,extensions,andbracket
areallincludedwiththehoodandarenecessaryfor
recirculationinstallation.Acharcoallter,notincluded,is
alsoneededforrecirculationinstallation.Thedamperis
notinstalledontheunitwithrecirculationinstallation.
1.Installtherecirculationductextensionstothe
recirculationduct.
2.Attachtherecirculationductmountingbrackettothe
recirculationductusingtheductcoverscrewsupplied
withthehardwarepackage.
3.Fittherecirculationductwithextensionsoverthe
ventexhaustoutletandpushdowntoseatonoutlet.
Attachtheverticalductworktothetopofthehood.
Checkthattherecirculationductisintheproper
orientation(holefacingtowardsthebackofthe
hood).
4.GotoMounttheGlass Range Hoodsection.
MOUNT THE GLASS RANGE HOOD
NOTE:Ifductless(recirculation)installation,followsteps
1-6.Ifductedinstallation,followsteps1-3.
1.Using2ormorepeople,lifttherangehoodandplace
onthehoodmountingbracket.Makesurethebracket
fullyengagestheholesonthehoodbody.
2.Placeamountingscrewintotheductcoveranchor
atthecenterslotprovidedonthebottomoftheback
sideofthehood.Securelytighten.
3.Securethehoodtothemountingbracketbyfastening
aductcoverscrewinhole(B)onbothsidesof
bracketshownpreviously
AttachUsing
DuctCover
Screw
Recirculation
Ductwith
Extensions
VentExhaust
Outlet
NOTE:Hole
mustbefacing
towardback
ofhood.
B
Hood
Mounting
Bracket
DuctCover
Screw
Hood
MountingScrew