Installation Instructions

LOCATION 95 - ACCOUNT CODE FOR PARTITION 4 (6 segments, numerical data)
The account code that is sent when reporting partition 4 is programmed in location 95. If location 95
is left unprogrammed (all “10”) then the account code corresponding to the phone number that is
dialled will be used. If the account code is less than six digits, program a “10” in the segment
immediately after the last digit of the account code. If the account code is 6 digits long, program all 6
segments.
LOCATION 96 - PARTITION 4 FEATURE AND REPORTING SELECTIONS (5 segments, feature
selection data)
Location 96 is used to enable certain features that the user can access or see from the keypad of the
system. In addition, certain communicator reports are enabled in this location. Each of these features
can be enabled by partition. This location contains 5 segments, with eight possible features per
segment. Refer to location 23 for the feature selections. If all the segments are blank (nothing
enabled), the features for partition 1 will be used.
LOCATION 97 - PARTITION 4 ENTRY EXIT TIMERS (6 segments, numerical data)
Location 97 is used to enter the entry and exit times in seconds. There are 2 separate entry and exit
times. Valid entries are 10-255 seconds. If all the segments are “0”, the entry and exit times for
partition 1 will be used.
Segment 1
Entry time 1 Entry time that will be used when a delay 1 zone type
initiates an entry delay
Segment 2
Exit time 1 Exit time that will be used for all zones designated as delay 1
Segment 3
Entry time 2 Entry time that will be used when a delay 2 zone type
initiates an entry delay
Segment 4
Exit time 2 Exit time that will be used for all zones designated as delay 2
Segment 5
Reserved
Segment 6
Reserved
Programming zone configuration groups
Locations 110-169 are used to change the zone configurations as listed in the table on page 96. These
locations are considered as advanced programming, and they should only be changed if you have a
thorough understanding of the operation of each bit.
LOCATION 110 - CONFIGURATION GROUP 1 ALARM EVENT CODE (1 segment, numerical data)
Location 110 contains the event code that is sent for a Contact ID or SIA report. The desired event
code should be chosen from the Table 38 or Table 39 in Appendix 1. The zone ID will be the zone
that is in alarm.
This location is not used for slow speed formats (like 4+2 and 3+1). This location may also contain
the alarm report code for the Robofon format (value 00-99).