Installation Instructions

Message Definition Action
Remote
Over-Current
The expansion module has detected an
excessive amount of current being
drawn from one of its outputs and has
disabled the output as a means of
protection.
Check the module for wiring faults.
Remote
Mains Fault
The mains power supply is not
connected to an expansion module
power supply.
Reconnect the mains power supply and ensure it
is working properly.
Remote
Siren Fault
The connection to an expansion
module’s siren is broken.
Repair the open circuit.
Remote
Trouble
An expansion module or keypad is not
reporting to the control panel.
Ensure that the module is connected properly to
the control panel.
Tamper
Zone X
There is a problem with the wiring or
the sensor is damaged.
Check the zone and zone sensors for damage and
repair any faults.
Zone Problem
Press OK
There is a problem with a zone or
zones. Press OK to identify the zone(s)
and the problem condition.
One of the following messages is
displayed when you press OK.
CleanMe
A specific smoke
detector (for example,
DP721) is dirty. The
panel detects a degree
of pollution in the
chamber of the
fire/smoke detectors.
Clean the detection chamber of the smoke
detector.
Note: This message is not shown on the LCD
display, only listed in the event log.
Open
There is a problem
with the wiring.
Check the zone and zone sensors for damage and
repair any faults.
Note: This message is displayed in case of wired
zones only.
Lost
The system has not
received RF sensor
transmissions for a
long period of time.
Depending on how the
system is
programmed, this
condition activates a
service report. In
addition, it may
activate a tamper
alarm if armed.
Ensure that the wireless zone module is receiving
power and has not been tampered with. Repair
any faults.
Low Battery
An RF sensor battery is
low.
Replace the battery.
Short Loss
The system has not
received RF sensor
transmissions for a
short period of time.
This condition prevents
arming.
Ensure that the wireless zone module is receiving
power and has not been tampered with. Repair
any faults.