Installation Instructions

NX-10 Installers manual

Exiting the program mode

When you have made all the desired changes in programming, it is time to exit the program mode.

Press the NO key twice to exit this programming level, and go to the “Enter the device address”

level. If no additional modules are to be programmed, press the NO key twice again to display the

OK to Exit prompt, and press OK to exit the program mode. If there is another module to be

programmed, you can select it by entering its address, followed by the [#] key (see Selecting the

module to program above).

Note: If you are not in a value selection mode nor in a value edit mode, you can press ## to display the OK to Exit

prompt. It also means you can exit any menu level immediately and display the OK to Exit prompt by

pressing [NO] [#] [#].

Note: You can set up the timeout for the program mode using the Control Panel>System

Settings>Timers>Miscellaneous>Programming Mode Timeout menu option, or by programming location

40, segment 14.