Full Product Manual

ManualsBrandsGE ManualsBar & Strip LightsLED Detachable Light Wand

Note: Remove batteries when not in use.

II. LIGHT MODE SELECTION:

Press the on/off button to cycle

through to the preferred light

mode. (see Fig. 2) This light

offers 3 modes for use: ON (full

brightness), ON (dim), and OFF.

III. INSTALLATION:

I. LOADING BATTERY:

1. Unscrew the button by twisting the end cap

counter-clockwise. A coin or ﬂat screwdriver

(not included) may be used if needed.

2. Push out the inner casing from the tube and

insert 3 “AAA” batteries (not included), noting the

correct polarity. Insert the casing back into the

tube and screw the end cap back on. (see Fig. 1)

360°

LED light wand

User Manual

MADE IN CHINA

GE is a trademark of General Electric Company and is under license by Jasco Products

Company LLC, 10 E. Memorial Rd., Oklahoma City, OK 73114.

This Jasco product comes with a limited-lifetime warranty.

Visit www.jascoproducts.com for warranty details and product registration.

Questions? Contact us at 1-800-654-8483 between 7:30AM—5:00PM CST.

12747 Manual v01

05/05/15 RT

Fig. 1

Fig. 2

Fig. 3

Fig. 4

1. Mount the light in the desired position using the

hook-and-loop tape (included) (see Fig. 3) or by

using a screw (included). Note the diagram in Fig.

4 for proper installation using a screw.

2. Turn the power on and set the mode you need.

3. Snap the light tube into the stand clip.

IV. FEATURES:

This device can be mounted nearly anywhere,

and can be positioned vertically or horizontally.

Additionally, the light can be detached from the

base to be used as a hand-held utility light

TAPE

• BATTERIES MAY LEAK HARMFUL

LIQUIDS OR IGNITABLE MATERIALS

OR EXPLODE CAUSING INJURY

AND PRODUCT DAMAGE

• DO NOT MIX OLD AND NEW OR

OTHER BATTERY TYPES

• REPLACE ALL BATTERIES AT THE

SAME TIME

• REMOVE BATTERIES IF PRODUCT

IS TO BE UNUSED FOR EXTENDED

PERIODS OF TIME

WARNING

3 x AAA

On/Off

button

Summary of content (2 pages)

PAGE 1
LED light wand User Manual I. LOADING BATTERY: 1. Unscrew the button by twisting the end cap counter-clockwise. A coin or flat screwdriver (not included) may be used if needed. 2. Push out the inner casing from the tube and insert 3 “AAA” batteries (not included), noting the correct polarity. Insert the casing back into the tube and screw the end cap back on. (see Fig. 1) Fig. 1 1. Mount the light in the desired position using the hook-and-loop tape (included) (see Fig. 3) or by using a screw (included).
PAGE 2
Varilla de iluminación LED Manual de usario I. LOADING BATTERY: 1. Unscrew the button by twisting the end cap counterclockwise. A coin or flat screwdriver (not included) may be used if needed. 2. Push out the inner casing from the tube and insert 3 “AAA” batteries (not included), noting the correct polarity. Insert the casing back into the tube and screw the end cap back on. (see Fig. 1) Fig. 4 IV. FEATURES: This device can be mounted nearly anywhere, and can be positioned vertically or horizontally.