Full Product Manual

Note: Remove batteries when not in use.
II. LIGHT MODE SELECTION:
Press the on/off button to cycle
through to the preferred light mode.
(see Fig. 2) This light offers 3 modes
for use: ON (full brightness), ON (dim),
and OFF.
III. INSTALLATION:
1. Mount the light in the desired position using the
hook-and-loop tape (included) (see Fig. 3) or by using a
screw (included). Note the diagram in Fig. 4 for proper
installation using a screw.
2. Turn the power on and set the mode you need.
3. Snap the light tube into the stand clip.
360°
Varilla de iluminación LED
Manual de usario
Fig. 4
Fig. 3
CINTA
Fig. 1
3 x AAA
Fig. 2
Botón de
encendido
y apagado,
HECHO EN CHINA
GE es una marca registrada de la companía General Electric Company y es utilizada bajo
licencia a la companía Jasco Prodcucts Company LLC, 10 E. Memorial Rd., Oklahoma City,
OK 73114.
Este producto de Jasco Products tiene una garantía limitada de por vida. Visite
www.jascoproducts.com para detalles.
¿Tiene preguntas? Comuníquese al 1-800-654-8483 entre las 7:30 a.m. y las 5:00 p.m. CST
(hora central estándar).
• LAS PILAS PUEDEN PERDER LÍQUIDOS
PERJUDICIALES O MATERIALES INFLAMABLES, O
EXPLOTAR Y CAUSAR LESIONES Y DAÑOS EN LOS
PRODUCTOS.
• NO COMBINE PILAS VIEJAS Y NUEVAS, NI TIPOS
DE PILAS DISTINTAS.
• REEMPLACE TODAS LAS PILAS AL MISMO TIEMPO.
• QUITE LAS PILAS SI NO USARÁ EL PRODUCTO
DURANTE PERIODOS PROLONGADOS.
ADVERTENCIA
IV. FEATURES:
This device can be mounted nearly anywhere, and can be
positioned vertically or horizontally. Additionally, the light
can be detached from the base to be used as a hand-held
utility light
I. LOADING BATTERY:
1. Unscrew the button by twisting the end cap counter-
clockwise. A coin or flat screwdriver
(not included) may be used if needed.
2. Push out the inner casing from the tube and insert
3 “AAA” batteries (not included), noting the correct
polarity. Insert the casing back into the tube and screw
the end cap back on. (see Fig. 1)