Full Product Manual

Surge Protector Instructions
1. Set the power switch to the “OFF” position. Plug the surge
protector into a standard grounding wall receptacle by fully
inserting the plug and ensure that there are no exposed
conductors.
2. Make sure electronic equipment is turned off before plugging
into the surge protector outlets. Do not use extension cords to
connect equipment to the surge protector.
3. Set the power switch to the “ON” position. The surge protector
will now be providing power and surge protection.
4. Connected equipment can now be turned on.
NOTE: Check the blue “Protected” and green “Grounded” indicator lights
periodically.
A glowing blue indicator light shows that surge protection is being provided.
If the blue “Protected” indicator light stops glowing, the
surge protective components have expired* and the power has been
permanently shut down to the outlets, ensuring surge protection for
your electronic equipment.
A glowing green indicator light shows that your surge protector is plugged
into a grounded receptacle and that your surge protector’s ground protection
components are providing protection from ground surges. If the “Grounded”
indicator light stops glowing, it is possible that the surge protector’s ground
protection components have expired or that the wall receptacle is no
longer grounded.
Surge Protector — Limited-Lifetime Warranty
Jasco Products Company warrants this surge protector to be free
of defects in workmanship and/or materials for the life* of the
surge protector. If such a defect should arise during the life of the
surge protector, Jasco Products Company will, at its option, either
repair or replace the surge protector without charge. This warranty
does not cover damage caused by lightning, accident, misuse, or
alterations to the surge protector.
* This surge protector, like all surge protectors, has a finite lifespan. Even
under normal circumstances and in the absence of defects, the product’s
life will expire when the surge protector’s component capacity has been
exceeded, thereby ceasing to provide protection from surges. In this event,
the Limited-Lifetime Warranty is no longer valid and the surge protector
should be replaced.
Warranty replacement procedure
1. Call Jasco Products Company Customer Information Center at
1-800-654-8483 to get a Return Authorization Number (RA#),
shipping instructions and a prepaid return address label.
2. After you have received the prepaid return address label, return
the Jasco Products Company surge protector, freight prepaid, to
Jasco Products Company. Surge protectors returned to Jasco
Products Company must have an RA# included in the mailing
address to be accepted.
3. The original purchaser will be asked to send the surge protector,
a copy of the sales receipt for the product, your name, address,
phone number and a description of the problem.
Connected Equipment Warranty
Equipment Replacement Guarantee for Surge Model: 14096
Maximum Warranty Amount: $400,000(USD)
NOTE: This device is not a lightning arrestor, so it will not afford protection
when lightning strikes nearby power line, the house, service entrance
or antenna. The Warranty is void if a power disturbance damages your
equipment through the coax, phone or network lines.
Jasco Products Company will pay up to the maximum warranty
amount offered for the surge protector purchased to repair or
replace up to an amount equal to the fair market value or the
original purchase price, whichever is less, of your electronics
equipment, if damaged by a transient surge (except those caused
by direct lightning), within the life* of the surge protector, while
properly and directly connected to this surge protector. JASCO
PRODUCTS COMPANY DISCLAIMS AND ASSUMES NO LIABILITY
FOR ANY OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES,
INCLUDING BUT NOT LIMITED TO LOSS OR DAMAGE TO SOFTWARE
OR DATA OR DAMAGES OR COSTS ASSOCIATED WITH BUSINESS
INTERRUPTION OR OTHER DAMAGES DUE TO LOSS OR DAMAGE TO
EQUIPMENT, SOFTWARE OR DATA. Some states do not allow the
exclusion or limitation of incidental or consequential damages,
so the above limitation or exclusion may not apply to you. This
warranty gives you specific legal rights, and you may also have
other rights that may vary from state to state.
This warranty is secondary to any existing coverage of any
connected equipment, including but not limited to, any
manufacturer’s warranty, extended warranties, or insurance
coverage.
To qualify for a connected equipment warranty:
1. All connected equipment must be UL and/or CSA approved.
2. The Jasco Products Company surge protector must be plugged
into properly wired and grounded outlets, no extension cords,
adapters, other ground wires, or electrical connectors may
be used, with the sole exception of other standard Jasco
Products Company 120 volt products approved for that use. The
installation must comply with all applicable electrical and safety
codes set forth pursuant to the National Electrical Code (NEC.)
3. Any claim under the warranty policy must be made within
15 days of the date of the alleged damage to the connected
equipment.
For connected equipment coverage, the following conditions
must be satisfied:
A) All equipment eligible for warranty coverage must be plugged
directly into the Jasco Products Company surge protector.
Equipment connected to the protected equipment, but not
plugged directly into the surge protector will not be covered.
B) The equipment must have been damaged by a covered power
disturbance that passed through the Jasco Products Company
surge protector.
C) The Jasco Products Company surge protector must be
damaged from the power disturbance.
D) The Jasco Products Company surge protector’s protection
capacity must not have been exceeded.
Connected equipment claim procedure:
1. Call Jasco Products Company Customer Information Center at
1-800-654-8483 to get a Return Authorization Number (RA#),
shipping instructions and a prepaid return address label.
2. After you have received the prepaid return address label, return
the Jasco Products Company surge protector, freight prepaid, to
Jasco Products Company. Surge protectors returned to Jasco
Products Company, Inc. must have an RA# included in the
mailing address to be accepted.
3. Jasco Products Company will determine whether the damage
to your equipment is covered by this warranty policy. If you are
covered, a claims adjuster will contact you and Jasco Products
Company will do one of the following at its own discretion:
a) Authorize a service center to repair damaged equipment.
b) Replace damaged equipment with equivalent or better.
c) Reimburse customer the fair market value of the damaged
equipment.
d) Reimburse customer the initial purchase price of the
damaged equipment (customer to provide dated bill of sale).
4. Jasco Products Company retains the right to determine whether
the damage to the connected equipment is due to Jasco
Products Company surge protector failure by requesting that
damaged equipment be sent to Jasco Products Company for
inspection.
FCC Statement:
This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation.
FCC NOTE: The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modifications to this
equipment. Such modifications could void the user’s authority to
14096 ver. 2
10/13/15 DA
MADE IN CHINA
GE is a trademark of General Electric Company and
is under license by Jasco Products Company LLC,
10 E. Memorial Rd., Oklahoma City, OK 73114.
This Jasco product comes with a limited-lifetime
warranty. Visit www.jascoproducts.com for warranty
details and product registration.
Questions? Contact us at 1-800-654-8483
between 7:30AM–5:00PM CST.
operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
RISK OF ELECTRIC SHOCK
• DO NOT USE IN WET LOCATIONS
• KEEP CHILDREN AWAY
• USE INDOORS ONLY
• FULLY INSERT PLUG
RISK OF FIRE
• DO NOT EXCEED ELECTRICAL RATINGS
NOT FOR USE WITH
• AQUARIUMS OR OTHER
WATER-RELATED PRODUCTS
• GENERATORS AND POWER INVERTERS
• MEDICAL LIFE-SUPPORT PRODUCTS
WARNING