Installation Instructions

USE TOP CABINET TEMPLATE FOR

PREPARATION OF TOP CABINET

B4.

•

Read the instructions on the TOP CABINET TEMPLATE.

• Tape it underneath the top cabinet.

• Drill the holes, following the instructions on the

TOP CABINET TEMPLATE.

CAUTION: Wear safety goggles when

drilling holes in the cabinet bottom.

Wall

Mounting

Plate

Spacing for Toggles More

Than Wall Thickness

Toggle

Bolt

Toggle Wings

To use toggle bolts:

Bolt End

Installation Instructions

You need to drill holes for the top support screws and a

hole large enough for the power cord to fit through.

Place the mounting plate against the wall and insert

the toggle wings into the holes in the wall

to mount the plate.

NOTE: Before tightening toggle bolts and wood screw,

make sure the tabs on the mounting plate touch the

bottom of the cabinet when pushed flush against the

wall and that the plate is properly centered under the

cabinet.

CAUTION: Be careful to avoid

pinching fingers between the back of the

mounting plate and the wall.

Tighten all bolts. Pull the plate away from the wall to

help tighten the bolts.

ATTACH THE MOUNTING PLATE

TO THE WALL

B3.

Attach the plate to the wall using toggle bolts. At least

one wood screw must be used to attach the plate to a

wall stud.

Remove the toggle wings from the bolts.

Insert the bolts into the mounting plate through the

holes designated to go into drywall and reattach the

toggle wings to

/4” onto each bolt.