Installation Instructions

WHEN REPLACING THE

CHARCOAL FILTER

C5.

MOUNT THE OVEN

(continued)

C4.

Slide the old filter down and out to remove it.

Remove plastic and other outer wrapping from the

new filter and install the new filter. When properly

installed, the wire mesh of the filter should be visible

from the front.

Replace the grille and the 2 screws.

Close the door.

If the model is not vented to the outside, the air will be

recirculated through a disposable charcoal filter that

helps remove smoke and odors.

The charcoal filter should be replaced when it is

noticeably dirty or discolored (usually after 6 to

12 months, depending on hood usage). See your

Owner’s Manual for the filter kit number.

To replace the charcoal filter:

Open the microwave door.

Remove 2 screws from the top of the grille. (You may

need to open the cabinet doors to remove the screws.

Slide the grille to the left and forward to remove.

Installation Instructions

Tighten the two screws to the top of the oven

completely. (While tightening screws, hold

the oven in place against the wall and the top

cabinet.)

Attach the oven to the top cabinet by inserting

2 self-aligning screws through outer top cabinet

holes. Turn two full turns on each screw. Be sure

to keep power cord tight. Be careful not to pinch

the cord, especially when mounting flush to

bottom of cabinet.

Install grease filters. See the Owner’s Manual

packed with the oven.

Insert filter mesh-side up

Charcoal

Filter