Use and Care Manual

1.8125" 1.8125" 1.8125" 1.8125"
1.8125"
2.9375"
INSTRUCTION MANUAL
Indoor Remote Wall Switch
Light Control
ENCLOSED YOU WILL FIND
• Receiver
• Wall Switch Remote Transmitter
• (1) 12V A23 Battery (installed)
Compliance with IC Rules and Regulations
IC: 18279
Company: Jasco Products Company
Model Number: 18279
Object is subjected to the following two conditions.
This device may not cause interference, and this device must accept
any interference, including interference that may cause undesired
operation of the device.
This class B digital apparatus complies with Canadian ICES-003.
OPERATING INSTRUCTIONS
1. Plug Receiver into a standard indoor outlet.
2. Plug device to be controlled into the outlet
on the Receiver.
3. Make sure outlet supplying Receiver is powered.
4. Make sure lamp or device is turned ON.
IMPORTANT: The device will remain OFF until the
Receiver is activated by the Transmitter.
REMOTE INSTRUCTIONS
Open the battery compartment on the transmitter
and remove the battery saver insert.
You can now control your device remotely using the
Remote Transmitter. A light on the Receiver turns on
when the unit is activated remotely, indicating that
power is being supplied to the lamp or device.
REPLACING BATTERY
1. Remove back battery cover.
2. Remove old battery.
3. Install new 12V type A23 alkaline battery,
noting polarity.
4. Replace battery cover.
TROUBLESHOOTING
If indicator light is not activated by pressing the switch...
1. Make sure switch is depressed and held for at
least 1 second.
2. Verify battery orientation, noting polarity
3. Replace the battery (USE ONLY 12V type A23 Alkaline).
4. Place the switch in a new location.
FOR INDOOR USE ONLY
CAUTION: DO NOT EXCEED ELECTRICAL RATINGS
RECEIVER
Functional Range ....................................................up to 100ft
Maximum Resistive Load.............................................1440W
Maximum Tungsten Load.............................................. 360W
Rating.............................................................12A / 120V / 60Hz
WALL SWITCH TRANSMITTER
Functional Range ................................................... up to 100ft
Battery Type............................... Use only 12V Alkaline A23
* Functional range may be adversely affected by one or
more of the following factors: weather, radio frequency
interference, low transmitter battery and obstructions
between the transmitter and receiver.
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
FCC NOTE: The manufacturer is not responsible for any
radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications
could void the user’s authority to operate the
equipment.
This equipment has been tested and found to comply
with the limits for a class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
18279-1 ver.1 06/12
This transmitter/receiver pair is NOT compatible
with other GE SmartHome™ remotes.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
GE is a trademark of General Electric
Company and is under license by
Jasco Products Company LLC,
10 E. Memorial Road,
Oklahoma City, OK 73114
WARNING
Risk of electric shock
• Fully insert plug
• Keep children away
• Use indoors only
• Do not use in wet locations
• Unplug before cleaning
Risk of fire
• Do not exceed electrical ratings
• Do not use to control motor-
operated appliances, transformer-
supplied appliances or appliances
that contain heating elements
(cookers, irons, heaters, etc.)
This Jasco product comes with a
90 day limited warranty.
Visit www.jascoproducts.com for details.