Product Manual

Equipment Overview
2040604-012D SEER
®
Light 2-13
Parameter Descriptions and Configuration
The following operating parameters can be configured for the recorder
and the controller.
Parameter Description
Heart rate synchronizing sound (controller) Heart rate synchronizing (shown as HR sound) can be set ON or OFF during the preview
of ECG waveforms. (OFF is the initial setting.)
Press the buttons to turn the selection ON or OFF.
Heart rate detection channel (controller) Used to select a recording channel to detect heart rate to calculate the heart rate and the
heart rate synchronizing sound during the preview of ECG waveform.
Selections are CH1, CH2, or CH3 (CH1 is the initial setting).
Press the buttons to select CH1, CH2, or CH3.
Auto start (recorder) If auto start is set to on, the controller will program the SEER Light recorder so it
automatically starts 30 minutes after batteries are installed.
Once the recorder is setup this way it will always automatically start in this manner unless
is it reprogrammed.
If auto start is set to off it will program the SEER Light recorder so it does not automatically
start 30 minutes after the batteries are installed
Press the buttons to turn the selection ON or OFF.
NOTE
The recorder will not Auto start if there is untransferred data in the recorder.