Product Manual

6-4 SEER
®
Light 2040604-012D
Transferring Data
4. Connect the cable to the data output connector of the recorder ( ).
5. Press the F2 button to enter the data transfer mode. Press the F6
button. The data will be transferred to the flash card.
6. You will be asked to confirm transfers under the following conditions.
Refer to “Confirming Flash Card Contents” on page 6-5 if this occurs.
 The flash card contains any data that has not been analyzed by
the Holter analysis system.
 The recording is stopped by pressing the button on the
recorder with a ball point pen, or removing the recorder’s
batteries, before recording 24 hours (48 hours if using the SEER
Light Extend recorder).
NOTE
An error message will appear on the screen if a flash card is
not inserted into the controller. Make sure the card is
inserted before attempting to transfer.
7. Data transfer is completed when the transfer progress bar on the
controller reaches 100%. Confirm the time displayed on the screen.
8. Remove the flash card by pressing the EJECT button.