Product Manual

Transferring Data
2040604-012D SEER
®
Light 6-5
35A
9. Disconnect the data transfer cable from the recorder. Switch off the
power supply by pressing the controller’s POWER button.
Confirming Flash Card Contents
You can confirm that the data transferred to the flash card through the
controller. This data includes:
 Patient information (ID, age, gender, and name)
 ECG waveform (close to the event point, close to the starting point,
close to the ending point, specific times) copied into the card
By confirming the contents of the flash card, the patient information can
be edited.
Confirming Patient Information
1. Insert the flash card into the controller.
NOTE
If the flash card is not inserted into the controller before starting the
operation, error messages will appear on the screen.
2. Press the F3 button to open Review mode, where you can confirm the
flash card contents.
3. Select Patient Information. Press ENT.
4. The patient information to be transferred from the recorder will be
displayed on the screen of the controller.
 Patient information can be edited. Refer to “Entering Patient
Data” on page 4-1.
 By pressing the F4 button after editing the data, a message
appears prompting you whether or not to save the edited data.